Wicked Audio EMBR True Wireless Earbuds User Manual

Wicked Audio EMBR True Wireless Earbuds

USER MANUAL

IMPORTANT SAFETY INSTRUCTION

1. Read these instructions.
2. Keep these instructions.
3. Heed all warnings
4. Follow all instructions.

Attention should be drawn to the environmental aspects of battery disposal;The use of apparatus in moderate climates

This device complies with Industry Canada licence-exempt RSS standard(s).

Operation is subject to the following two conditions: (1) This device may not cause interference, and (2) This device must accept any interference, including interference that may cause undesired operation of the device.

In the Box

• Embr TWS Earbuds
• Charging Case
• USB to Micro-USB Charging Cable
• 3 Sizes of Cushions
• Instruction Booklet

Turning Earbuds On/Off

Power On

Removing earbuds from the case automatically turns on the earbuds and starts the syncing process to one another, OR

Power On (outside of case)

When outside the charging case and powered off, long press both earbuds for 3-5 seconds (Red/Blue LED will flash) to turn them on.

Power Off

Placing the earbuds back into the charging case will automatically power them down. OR

Power Off (outside of case)

Long press left and right earbud for 4 seconds to turn off earbuds without putting them in the case.

Charging

Charging the Charging Case
Using the Micro-USB charging cable, plug into a power source. While charging the charging case LEDs will flash white.
Once fully charged, the 4 LEDs will be solid white.

Place earbuds in charging case to charge earbuds.
They will turn off and automatically begin charging. While charging the earbuds, the charging case LEDs will be a solid white. When the earbuds are fully charged the charging case LEDs will shut off.

Tip: Earbuds will announce “low charge” when they are at 10% battery life.

LEDs

Charging Case Lights when Charging Case:

• Flashing White LEDs 4 LEDs Solid White
• Case is Charging Full Charge Reached

Charging Case Lights when Charging Earbuds:

• Solid White LEDs LEDs shut off
• Earbuds are Charging Earbuds fully charged

Functions

Pause / Play
Single Press (Left or Right Earbud)

Next Track
Double Press (Right Earbud)

Previous Track
Double Press (Left Earbud)

Enter / Exit Voice Assistant
Triple Click (Left or Right Earbud)

Volume Up
Long Press (Right Earbud)

Volume Down
Long Press (Left Earbud)

Answer Call/Hang up Call
Single Press (Left or Right Earbud)

Reject Incoming Call
Long Press 2 Seconds (Left or Right Earbud)

Troubleshooting

Reset

Only one earbud connecting to device at a time?

1. From your device’s Bluetooth menu, delete “Wicked Embr” pairing name
2. Place earbuds in charging case.
3.  Remove one earbud from charging case.
4. Press earbud button 4 times and return to charging case.
5. Remove the other earbud from charging case.
6. Press earbud button 4 times and return to charging case.
7. Remove both earbuds from charging case.
8. Earbuds will start the syncing process to each other.
9. Once synced you can then locate “Wicked Embr” in your Bluetooth settings to pair to your device.

PRECAUTIONS

LISTENING TO AUDIO AT EXCESSIVE VOLUMES CAN CAUSE PERMANENT HEARING DAMAGE. USE AS LOW A VOLUME AS POSSIBLE.

Over exposure to excessive sound levels can damage your ears resulting in permanent noise-induced hearing loss (NIHL). Please use the following guidelines established by the Occupational Safety Health Administration (OSHA) on maximum time exposure to sound pressure levels before hearing damage occurs.

SAFE USE & HAZARD WARNINGS

90 dB SPL at 8 hours| 95 dB SPL at 4 hours| 100 dB SPL at 2 hours| 105 dB SPL at 1 hours
---|---|---|---
110 dB SPL at 30 min| 115 dB SPL at 15 min| 120 dB SPL: Avoid as damage may occur

MODEL #: WI-TW505X
IC: 20526-WITW505X

LIMITED ONE-YEAR WARRANTY

Keep your receipt to obtain warranty service. Go to
www.wickedaudio.com for more details.
Developed in Utah, U.S.A.

Made in China

Limitation of Liability

Any Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.The device has been evaluated to meet general RF exposure requirement. The device can be used in portable exposure condition without restriction.

In no event, under any cause of action of theory of liability, shall Wicked Audio Inc., its distributors or suppliers be liable to you or any third party for indirect, incidental, consequential, special, exemplary or punitive damages, of any and all nature whatsoever, arising out of use of or inability to use a product. This includes without limitation, property damage, loss of value of the product or any third party products that are used in or with the Wicked Audio products, even if the Wicked Audio product has been advised of the possibility of such damages that one may encounter. Without limiting the foregoing, you understand and agree that Wicked Audio has no liability for any damages or destruction to the consumer electronics devices or other personal property that are contained in inside or outside the Wicked Audio products. This includes without limitation, laptops, cellular phones, or other hand-held devices, or any loss of data contained on the foreign device.

Notwithstanding any damages that you might incur for general damages in contract, tort (including negligence) or otherwise), the entire aggregate liability of Wicked Audio and any of its distributors and/or suppliers shall be limited to the amount actually paid by you for the Wicked Audio product giving rise to liability. Some states and/or jurisdictions do not allow the exclusion or limitation of incidental or consequential damages, so the above limitations or exclusions may not apply to you. The limitations of liability set forth above shall apply to the maximum extent permitted under applicable law.

DOWNLOAD

Wicked Audio EMBR True Wireless Earbuds User Manual – [Download PDF]

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>