KFi Products 100425 Gen4 Double Tube Bumper Winch Mount Instructions
- June 13, 2024
- KFi PRODUCTS
Table of Contents
KFi Products 100425 Gen4 Double Tube Bumper Winch Mount
Product Information
Product Name: Polaris Gen 4 Double Tube buMPeR Winch Mount
Part Number: 100425
Kit Components:Item # | Qty. | Description |
---|---|---|
1 | 1 | Winch Mount |
2 | 1 | HK-002 |
2.1 | 4 | M8-1.25 X 1.00 Flat Head Cap screw |
2.2 | 4 | 5/16-18 X 1.00 Hex nut Nylock GR5 |
2.3 | 4 | 5/16 Flat Washer |
2.4 | 4 | 5/16-18 Hex nut Nylock GR5 |
*2.5 | 4 | *5/16-18 X 1.00 Flat Head Cap screw – not used |
Figure 1
Product Usage Instructions
Figure 2
-
1. If your bumper is already installed on your ATV, remove it.
- Connect the winch motor wires to your winch.
- Assemble the winch to the mount plate using the supplied Flat Head screws (refer to Figure 1).
- Assemble your roller or hawse fairlead to your bumper using the hardware supplied with your winch.
- Assemble the winch and mount assembly to the bumper using the supplied 5/16 hardware (refer to Figure 2 and 3). At the same time, feed your cable through the Roller or Hawse Fairlead.
Figure 3
- Reassemble the bumper to your ATV.
- Follow the instructions provided with your winch for wiring accordingly.
Note: Make sure all hardware needed to complete this mount is in the package. Thoroughly read through and understand the instructions before installing.
Date of Manual: 06/09/23
Winch Mount PART #100425
Kit Components
Item #| Qty.| Description
1| 1| Winch Mount
2| 1| HK-002
2.1| 4| M8-1.25 X 1.00” Flat Head Cap screw
2.2| 4| 5/16”-18 X 1.00” Hex nut Nylock GR5
2.3| 4| 5/16” Flat Washer
2.4| 4| 5/16”-18 Hex nut Nylock GR5
2.5| 4| 5/16”-18 X 1.00” Flat Head Cap screw – not used
Note: Make sure all hardware needed to complete this mount is in the package. Thoroughly read through and understand the instructions before installing.
Installation Instructions
- If your bumper is already installed you will need to remove it from your ATV.
- Connect the winch motor wires to your winch and then assemble the winch to the mount plate as shown in Figure 1 using the supplied Flat Head Screws.
- NOTE: Also make sure you pull your cable through the cable hole in the plate.
- Assemble your roller or hawse fairlead to your bumper with the hardware that was supplied with your winch.
- Assemble the winch and mount assembly to the bumper with the supplied 5/16” hardware as shown in Figure 2 and 3. At the same time feed you cable through the Roller or Hawse Fairlead.
- Reassemble the bumper to your ATV.
- Using the instructions provided with your winch, wire accordingly.
©2023 Copyright Kappers Fabricating, Inc. All rights reserved.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>