Outwell 650857 Leonis Lux Lamp Instruction Manual

: June 13, 2024
: Outwell

Table of Contents

Outwell 650857 Leonis Lux Lamp
Product Information:
Product Usage Instructions
To use the LEONIS LUX lamp, follow the instructions below:
PRODUCT IDENTIFICATION
Light modes
Use of the lamp
Light source: LED
Technical data:
References
Read User Manual Online (PDF format)
Download This Manual (PDF format)

Outwell 650857 Leonis Lux Lamp

Outwell 650857 Leonis Lux Lamp-product

Product Information:

Product Name: LEONIS LUX
Light Source: LED
Energy Efficiency Class: E
Replaceable Light Source and Control Gear: No
Input (AC/DC Adapter): 100-240V, 0.3A
Output (AC/DC Adapter): 5V, 2A
Input (Lamp Unit): 5V
Class: 2 appliance

Product Usage Instructions

To use the LEONIS LUX lamp, follow the instructions below:

Connect the AC/DC adapter to a power source with an input voltage of 100-240V and an output of 5V, 0.3A.
Attach the lampshade to the lamp body by extending it fully. The extended lampshade will cover the LED light source.
To turn on the lamp, press the button located on the lamp body.
The light can be dimmed to any desired setting between minimum and maximum light output. Adjust the dimming level by rotating the edge of the lampshade.

Note: The light source and control gear of the LEONIS LUX lamp are not replaceable. Disassembly of the lamp for disposal should be done following the instructions provided in the user manual.

PRODUCT IDENTIFICATION

Light modes

Press the button (1.) to switch on / off the light.
Press and hold the button to dim the light. The light can be dimmed step-less to any setting between maximum and minimum light output.

Use of the lamp

Lamp is powered by 100-240V AC.
To extend lantern lampshade, grab the edge of the lampshade (6.) and push the body out from the inside, do not pull on the cord.
To collapse the lampshade, reverse the above.
Hang lamp from the hanging point, adjust height as needed by gently moving the cord through the adjuster.
For indoor use only.
Lamp can be cleaned with a damp rag.
Do not use corrosive liquids to clean the lamp.
Do not stare into the light source.

Light source: LED

This product contains a light source of energy efficiency class E.
Light source and control gear are not replaceable.
This would introduce weak points in the construction, that could reduce the lifetime of the product.

Outwell 650857 Leonis Lux Lamp-fig7

Instruction for removal of light source and control gear by market surveillance authorities:

Remove lamp lens by using a flat head screwdriver to open the four tabs.
Unscrew 2 pcs screws holding PCB with LEDs in place.
Cut needed wires to remove the required components for testing.

Instruction for disassembly of lamp for disposal of components when lamp has reached the end of its usable life:
– See steps 1-2 above

Cut wires and remove screws to allow removal of electronics on circuit board. Dispose of electronics according to local regulations.
Dispose of remaining components according to local regulations.