Avanti DD1-21 5.8 Cu. Ft. White Upright Freezer Instructions
- June 13, 2024
- Avanti
Table of Contents
Avanti DD1-21 5.8 Cu. Ft. White Upright Freezer
Product Information
This product is a door hinge bracket and stopper kit. It is designed to be used with doors and helps in aligning and securing them properly. The kit includes a hinge bracket, door stoppers, hinge cover, and screw cover.
Product Usage Instructions
- Remove the top right hinge cover by gently pulling it off.
- Undo the screws holding the hinge bracket in place. Once the screws are removed, carefully detach the hinge bracket from the door.
- Locate the door stopper on the bottom right side of the door and remove it.
- From the accessory bag, find the left-side door stopper and install it on the bottom left side of the door. Make sure it is securely attached.
- (Optional steps 6-9 are missing in the provided text)
- Put the hinge cover back in its original position by aligning it properly and pressing it firmly until it snaps into place.
- Similarly, put the screw cover back by aligning it with the screw holes and pressing it until it is securely attached.
- Close the doors and check if they are aligned horizontally and vertically. Ensure that the seal is closed on all sides.
- If necessary, tighten the bottom hinge to ensure proper alignment. Use a suitable screwdriver to tighten the screws.
- If needed, re-adjust the leveling feet to ensure stability and balance.
Note: Steps 6-9 are missing in the provided text, so please refer to the complete user manual for detailed instructions on those steps.
Reverse Door
Tool required: Philips screwdriver, Flat bladed screwdriver, Hexagonal spanner.
- Ensure the unit is unplugged and empty.
- To take the door off, it is necessary to tilt the unit backward. You should rest the unit on something solid so that it will not slip during the door-reversing process.
- All parts removed must be saved to do the reinstallation of the door.
- Do not lay the unit flat as this may damage the coolant system.
- It’s better that 2 people handle the unit during assembly.
INSTALLATION INSTRUCTION
- Remove the top right hinge cover.
- Undo the screws. Then remove the hinge bracket.
- Remove the top left screw cover.
- Move the core cover from the left side to the right side. And then lift the upper door and place it on a padded surface to prevent it from scratching.
- Remove the door stopper from the bottom right side of the door. Find the left-side door stopper in the accessory bag and install it on the bottom left side of the door.
- Unscrew and remove the bottom hinge pin, turn the bracket over, and replace it.
- Refit the bracket fitting the bottom hinge pin. Replace both adjustable feet.
- Detach the Fridge and the Freezer door gaskets and then attach them after rotating.
- Place the upper door back on. Ensure the door is aligned horizontally and vertically so that the seals are closed on all sides before finally tightening the top hinge.
- Insert the hinge bracket and screw it to the top of the unit.
- Use a spanner to tighten it if necessary.
- Put the hinge cover and the screw cover back.
- With the doors closed, check that the doors are aligned horizontally and vertically and that the seal is closed on all sides before finally tightening the bottom hinge.Re-adjust the levelling feet as needed.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>