makita MAL 3709 Trimmer Teal Instruction Manual

: June 4, 2024
: Makita

Table of Contents

MAL 3709 Trimmer Teal
Read User Manual Online (PDF format)
Download This Manual (PDF format)

MAL 3709
Mounting instructions makita MAL 3709 Trimmer Teal
-

MAL 3709 Trimmer Teal

Safety directions / Please read t his information carefully before installing or using this product. Please keep this user manual for further reference.

The lamps may only be installed by authorized and qualified technicians according to the valid regulations for electrical installation.
The manufacturer does not accept any responsibility for injuries or damage resulting from improper use of the light.
Maintenance of the lights is limited to the surfaces. For electrical safety reasons, this product must not be cleaned with water or other liquids. Use only a dry, lint-free cloth for cleaning.
Caution! Risk of electric shock. Before connecting to the mains, always check the entire light for possible damage. Never use the light if you notice any damage.
Caution! Disconnect the main cable from the power supply before assembling or disassembling. Switch off the earth leakage circuit breaker/automatic circuit breaker or unscrew the fuse. Turn the switches to “OFF”.
Caution! Before drilling the mounting holes, make sure that no gas, water or electricity pipes and wires can be drilled through or damaged in your chosen mounting location.
When mounting, ensure that the attachment material is suitable for the subsurface and that this surface is capable of carrying the weight of the fixture. The manufacturer is not liable for improper installation of the item on the relevant subsurface.
The symbol of the crossed-out garbage can on the product or the packaging means that the product must not be disposed of with ordinary household waste. At the end of its useful life, the product must be returned to a point of acceptance for the recycling of electric and electronic devices. Please ask your local municipality for the point of acceptance.
Safety class I . This light must be connected to the earthed conductor-terminal with the earthed conductor (green-yellow wire) .
Description of the supply terminals: L = Phase N = Neutral conductor ****= Earthed conductor.
Protective covers and end covers for mains voltage control parts must always be mounted.
Do not install the light on a damp or conductive subsurface.
Please make sure that no cables get damaged during the installation work.
Attention! During operation, lamp parts and illuminants can reach temperatures of more than 60°C. Do not touch during operation!
The lights have a protection class rating of “IP20“ and are solely intended for indoor use only in private households.
Do not look directly into the light source (illuminant, LED, etc.).
The included or insertable LED light bulb contained in this luminaire shall only be replaced by the manufacturer or his service agent or a similarly qualified person.
This product contains a light source of energy efficiency class “E“, based on the EU regulation 2019/2015.
LED colour deviation when using different chargers may occur. The light colour and luminous strength of the LEDs can also change as a result of the life span level of the lamp.
This article is not suitable for use with dimmable electric circuits. It can be controlled using the accompanying remote control.
The lights can only be switched on by remote control when there is no obstruction between the remote control and the lights.
Switching on the lamp with the “CW ON/OFF“ button on the remote control does the following: Only the “CW“ area will be switched on. Channel „RGB“ is switched off.
Switching on the lamp with the “RGB ON/OFF“ button on the remote control does the following: Only the “RGB“ area will be switched on. Channel „CW“ is switched off.
The “Dim+“ and “Dim-“ buttons brighten and dim the lights either in stages or continuously.
The “Night Light” button switches the lights to their dimmest setting with a colour temperature of approximately “3000K”.
Briefly pressing the “FLASH“ button switches on the following function: A repeated colour run of fixed single colours.
Briefly pressing the “SMOOTH“ button switches on the following function: Repeated, merging colour change of all colours
With the button “RGB“, “7“ determined colour variants can be selected one after the other. The selected colours are not dimmable.
The “20%/50%/100%“ button consecutively switches through the adjustable dimming levels from “100%” to “20%”.
The “Timer” button switches the lights off after “30” minutes.
Memory function: switching on the light using the remote control or an external light switch always activates the last light colour and dimming level set.
Batteries or rechargeable batteries are not permitted in domestic waste. They must be decontaminated according to the regulations of the responsible authorities as hazardous waste. Use the available collection points.