WaterPik WP-150 Ultra Plus Water Flosser User Guide
- June 13, 2024
- Waterpik
Table of Contents
WaterPik WP-150 Ultra Plus Water Flosser
Product Information
The WP-150 Series is a water flosser device manufactured by Waterpik. It is designed to provide efficient and effective oral hygiene by utilizing a combination of water pressure and pulsations to remove plaque and debris from between teeth and below the gumline. The device operates on a voltage of 120 VAC, 60 Hz.
Product Usage Instructions
- Unit Prep: Before using the water flosser, it is recommended to visit waterpik.com/welcomeWF and register your product to receive over $50 in savings at waterpik.com/registration. Fill the reservoir with warm water and firmly replace it on the base.
- Water Floss:
- Turn the power switch ON.
- Insert the flossing tip until it clicks into place.
- Turn the pressure switch to high, point the tip into the sink, and turn both the power and water switches ON until water flows. Then, turn both switches OFF.
- To start flossing, turn the power and water switches on. Begin with low pressure and gradually increase to your preference.
- While flossing, keep your lips closed enough to prevent splashing, but still allow water to flow from your mouth into the sink.
- To avoid mess, always keep the flossing tip in your mouth while the unit is on.
Note: The instructions provided above are in English. For Spanish instructions, refer to the Spanish section of the manual.
Unit Prep
- Fill reservoir with warm water and replace it firmly on the base.
- Insert tip until it clicks into place.
- Turn pressure to high, point tip into sink, turn power and water switches ON until water flows. Turn switches OFF.
Water Floss
- Turn power and water on. Start on low pressure and increase to your liking.
- Close lips enough to prevent splashing, while still allowing water to flow from mouth into the sink.
- Aim water at a 90° angle to your gumline. Follow the gumline and pause briefly between teeth.
TO AVOID MESS: KEEP TIP IN MOUTH WHILE UNIT IS ON.
This device is compatible with voltages of 120 VAC, 60 Hz. ©2019 Water Pik, Inc.
Visit
waterpik.com/welcomeWF Register your product
and receive over $50 in savings.
waterpik.com/registration
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>