nVent HOFFMAN ANADFK NEMA Swing Out Panel Kit Instruction Manual
- June 13, 2024
- nVent HOFFMAN
Table of Contents
NEMA Swing−Out Panel Kit
ANADFK NEMA Swing Out Panel Kit
WARNING
To avoid electric shock and equipment damage, disconnect any power supplies to
the enclosure before drilling mounting holes. Do not energize any circuits
before all internal and external electrical and mechanical clearances are
checked to assure that all assembled equipment functions safely and
properly.
This accessory maintains UL/CSA Type 12,4,4X
when installed per these instructions.
This accessory is covered by UL file E61997 and CSA file LR42186.
INSTALLATION STEPS
Step 1 − Swing panel may be hinged on any side. Determine mounting
position desired and drill eight .312 (8mm) diameter holes as shown on page 6.
Step 2 − Mount hinges and securing brackets using pan head screws with
nylon washers under the screw heads. In order to meet NEMA 4 and NEMA 12
standards, nylon washers must be used.
Step 3 − Mount swing panel to hinges with 3/8” hex head bolts,
lockwashers, and hex nuts. Adjust panel until panel swings freely through the
door opening.
Step 4 − Captivate thumb screws to panel using retaining rings provided.
Step 5 − On larger enclosures or with heavy panel loading, be sure to
drill two holes in swing panel and install two bolts per hinge as shown.
 Rev. D
© 2018 Hoffman Enclosures Inc.
PH 763 422 2211
nVent.com/HOFFMAN
P/N 99401469
87568919
Documents / Resources
|
nVent HOFFMAN ANADFK NEMA Swing Out Panel
Kit
[pdf] Instruction Manual
ANADFK NEMA Swing Out Panel Kit, ANADFK, NEMA Swing Out Panel Kit, Swing Out
Panel Kit, Out Panel Kit, Panel Kit
---|---
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>