nVent HOFFMAN APMK3RL014 Revere Electric Supply Instructions
- June 12, 2024
- nVent HOFFMAN
Table of Contents
nVent HOFFMAN APMK3RL014 Revere Electric Supply
Product Information
This product is an enclosure that is designed to securely hold and protect electronic components. It features a back panel with square knockouts and comes with carriage bolts, standoff nuts, washers, and nuts for installation.
Product Usage Instructions
- Begin by removing the four square knockouts located at the back of the enclosure. These knockouts are designed to provide access for cables or wires.
- Take the carriage bolts provided and insert them through the holes where the knockouts were removed. Ensure that the bolts are inserted from the outside of the enclosure towards the inside.
- Once the carriage bolts are in place, fasten them securely using the large standoff nuts. Tighten the nuts until they are firmly secured to the enclosure.
- Now, take the panel that is meant to be installed over the standoff nuts. Position it over the nuts and align it properly with the holes on the enclosure.
- Using the washers provided, place a washer over each standoff nut. This will help distribute the pressure evenly and prevent any damage to the panel or enclosure.
- Finally, secure the panel in place by fastening the nuts onto the carriage bolts. Make sure to tighten them adequately, but avoid over-tightening to prevent damage.
By following these instructions, you will be able to install the panel securely onto the enclosure using the provided hardware.
OVERVIEW
INSTALLATION INSTRUCTION
- Remove four square knockouts in the back of the enclosure.
- Insert carriage bolts through the back of the enclosure, and fasten them with the large standoff nuts.
- Install panel over standoff nuts, secure in place with the washers and nuts as shown.
- 2019 Hoffman Enclosures Inc. PH 763 422 2211
- nVent.com/HOFFMAN P/N 99401602 87568962
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>