nVent HOFFMAN ADP1 Small 6 Inch Data Pocket Installation Guide
- June 12, 2024
- nVent HOFFMAN
Table of Contents
ADP1 Small 6 Inch Data Pocket
Installation Guide
ADP1 Small 6 Inch Data Pocket
FASTENER| 3| D| H| ENCLOSURES USED ON|
APPLICATION
---|---|---|---|---|---
| . 34
8.71mm| .45
11.43mm| .15 3.91mm| Painted steel with non-threaded studs| Twist on with
Nutdriver
.375
9.52mm| .562
14.27mm| .223
5.66mm| Aluminum
| . 344
8.74mm| .469
11.91mm| . 212
5.38mm| Painted steel with threaded M4 studs| Twist on with Nondriver
.354
8.99mm| .472
11.99mm| .222
5.64mm| Stainless steel
| N/A| 12.70mm| 500
N/A| All Applications| Pressure Sensitive Adhesive
- Door shown is for illustration only; your door may look different.
STEP 1: Using table above, determine which method of mounting is appropriate for your situation.
STEP 2: If mounting studs are to be used, place print pocket over appropriate studs and apply fastener.
STEP 3: Double-backed tape may be used instead of or in addition to fasteners (thermoplastic data pockets only).
Cut tape to length, remove backing from one side, and apply to rear surface of print pocket flange.
STEP 4: If using mounting studs and tape, pierce holes through tape as required. Remove remaining tape backing and press data pocket into place.
© 2018 Hoffman Enclosures Inc.
PH 763 422 2211
nVent.com/HOFFMAN
P/N 64367001
Documents / Resources
|
nVent HOFFMAN ADP1 Small 6 Inch Data
Pocket
[pdf] Installation Guide
ADP1 Small 6 Inch Data Pocket, ADP1, Small 6 Inch Data Pocket, Data Pocket,
Pocket
---|---
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>