KENWOOD CA-GRL14RG Speaker Grilles Instruction Manual
- June 12, 2024
- KENWOOD
Table of Contents
KENWOOD CA-GRL14RG Speaker Grilles
Product Information
- Product Model: CA-GRL14RG
- Manufacturer: JVCKENWOOD Corporation
Important Notes
- The following instructions are for the installation of Metal Mesh Speaker Grilles.
Metal Mesh Speaker Grilles Installation Instructions
Installation Procedure
- Before beginning the installation, make sure to remove the factory clips carefully. Use your thumbnails or a flat edge to gently pry the 2 ends apart and pull up to release each clip from the stock grille (see Fig 1.1).
- Ensure that you do not put a flat edge under one end only, as it may cause the clip to break. Both ends of the clip must be pried apart to release it.
- On the back side of the grilles, you will find tabs that are part of the metal mesh. These tabs are folded over to secure the mesh to the plastic trim ring. If needed, fold these tabs back up to allow easy separation of the ring and mesh for painting or customization purposes.
- The metal mesh is thick enough to withstand powder coating, polishing, chroming, or other similar processing without warping.
For updated information, including the latest Instruction Manual, please visit the following website: https://manual.kenwood.com/en_contents/search/
Important Notes
©2023 JVCKENWOOD Corporation. All Rights Reserved. KENWOOD® and eXcelon® are registered trademarks of JVCKENWOOD Corporation. Harley-Davidson®, Electra Glide®, Road Glide®, Street Glide®, Ultra Classic®, Tri Glide®, CVO™, Screamin Eagle® and Tour-Pak® are trademarks or registered trademarks of Harley- Davidson, Inc. and/or its affiliates and if used or implied are for reference only. There is no affiliation between Harley-Davidson, Inc. and/or its affiliates and JVCKENWOOD Corporation and/or its affiliates. All other trademarks are the property of their respective owners. Specifications subject to change without notice.
Take the time to read through this instruction manual.
Familiarity with installation and operation procedures will help you obtain
the best performance from your new product.
Installation procedure
- Each factory grille will need to be removed from the inner fairing by prying up on them. Start with your fingers, but if you must use a tool, use something with a 90° end, being extra careful not to scratch your inner fairing.
- On the back of each stock grille, you will see a rubber gasket and 2 white clips. These gaskets and clips need to be removed from the factory grilles and re-installed on the KENWOOD grilles.
- Once the gaskets and clips are installed onto the new grilles, simply press the new grilles back onto your inner fairing.
NOTE : The factory clips in step 2 must be removed carefully. Using your thumbnails or a flat edge under each side, gently pry the 2 ends apart (see Fig 1.1) and pull up to release each clip from the stock grille. If you put a flat edge under one end only, the clip cannot release and could break
NOTE: On the back side of the grilles, you will see tabs that are part of
the metal mesh which are folded over to secure the mesh to the plastic trim
ring. Folding these tabs back up allows the ring and mesh to separate easily
for paint etc. For custom applications, the metal mesh is thick enough that it
should not warp during powder coating, polishing, chroming, or other similar
processing
For updated information (the latest Instruction Manual, etc.), please visit
the following website:
https://manual.kenwood.com/en_contents/search/
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>