iLIVING ILG8EOSC18 Outdoor Oscillating High Velocity Wall Fan Owner’s Manual
- June 12, 2024
- iLIVING
Table of Contents
iLIVING ILG8EOSC18 Outdoor Oscillating High Velocity Wall Fan Owner’s
Manual
VERY IMPORTANT SAFETY INFORMATION
- This fan is suitable for outdoor use.
- This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety.
- Children should be supervised to ensure that they do not play with the appliance.
- If the supply cord is damaged, it must be replaced by the manufacturer, its service agent or similarly qualified persons in order to avoid a hazard. Do not use an extension cord with this fan.
- To reduce the risk of injury to persons, install wall mounting fan at least 2.1m (7 feet) above the floor
CAUTION: To reduce the risk of electric shock, connect only to an outlet
provided with a ground fault circuit interrupting device.
DANGER: Do not submerge motor in water or allow motor to be exposed to
water. Personal injury and/or death could result. Never handle the fan or
motor with wet hands or when standing on wet or damp surface or in water.
Fatal electrical shock could occur.
WARNING: Electric shock hazards—may cause severe personal injury or
death. For your safety, turn off the electrical power supply before
installing, moving, or servicing your fan to avoid any possible electrical
shock hazards. Never make adjustments to the fan when in power is on.
WARNING:
Risk of electrical shock—This fan is supplied with a grounding conductor and
GFCI type plug. To reduce the risk of electrical shock, make sure that it is
connected only to a PROPERLY grounded outlet. Use only on GFCI protected
receptacles. Do not under any circumstances remove the power plug’s ground
prong or ground fault unit. For your personal safety, the fan must be
grounded. The fan is equipped with a power supply with ground fault circuit
interrupting device. Removal or tampering of power cord will void warranty.
Never use an extension cord to connect the fan to an outlet. All installations
must be made into a grounded outlet.
UNPLUG THE FAN WHEN NOT IN USE.
WARNING: To reduce the risk of fire or electrical shock, do not use this
fan with any solid state speed control device. This appliance has a 3-prong
plug. To reduce the risk of electrical shock, this plug is intended to fit in
an outlet only one way. If this does not fit outlet, contact a qualified
electrician. Do not attempt to bypass this procedure
ASSEMBLY INSTRUCTIONS
CAUTION.
BEFORE ASSEMBLING FAN TO MOUNTING BRACKET MAKE CERTAIN THAT THE BRACKET SUPPORT WALL CAN SUPPORT FAN.
Stet 1: Drill two holes in the wall according to the installing size on
the bracket base. Attach the bracket base mounting to strong wall with
expansion bolt.
Stet 2: Hang the Wall mounting bracket upward onto the bracket base.
Assembling the knob to mounting bracket, tighten firmly.
Stet 3: Install supporting connector of the fan motor on the wall
mounting bracket with position screw, pivot bolt, washer spring washer and
nut, tighten firmly.
Stet 4: Then assembling the rear guard, blade, front guard to the fan
motor.
OPERATING INSTRUCTIONS
SPEED CONTROL:
Select air speed by setting switch to either high(3) – medial(2) – low(1) –
off(0).
SETTING OSCILLATING MODE:
- TO MAKE THE FAN OSCILLATE: Press down the oscillation knob at the top of the fan head.(See Figure A.)
- TO STOP THE FAN OSCILLATE: Pull up the oscillation knob at the top of the fan head. (See Figure B.)
CLEANING
WARNING: Unplug from electrical supply source before cleaning.
- Use soft damp cloth then wipe with dry cloth.
- Do not use harmful cleaners to paints or plastics.
- Do not bend the blades.
RATING:
ILG8EOSC18: 120V~ 60Hz, 1.0A, 115W
ILG8EOSC20: 120V~ 60Hz, 1.0A, 120W
Warranty
This fan comes with a 1-YEAR LIMITED COMPONENT WARRANTY. If your unit does
not appear to be working properly, please contact our service center by
calling 1-800-317-1688.
Prior to your call, we encourage you to visit our service-related website
www.ilivingusa.com for troubleshooting tips and
service instructions if needed
Warranty Information
Register your product at our website: Or visit iLivingUSA.com/register- product
Feedback
Love it ? Help us make the product more for you. Let us know with a
customer review.
Please visit: https://www.amazon.com/review/review-your-
purchases#
At iLiving USA, we are committed to bringing top quality products to our
customers. iLIVING USA 860 Mahler Road，Burlingame CA 94010
Tel: 1- 800-317-1688
Email: [email protected]
Like us on Facebook: https://www.facebook.com/ilivingusa/
Follow us on Twitter: @iLIVINGUSA
