LIQUID EARS LE2OBTOHBK Wireless Over-Ear Headphones User Manual

LIQUID EARS LE2OBTOHBK Wireless Over-Ear Headphones

Specifications

• Driver Size : 40mm
• Impedance : 32 Ohm #15%
• Sensitivity: 99dB ‡ 3dB at 1kHz
• Frequency Response : 20Hz – 20kHz
• Wireless Range : 10m
• Play Time : 40 Hours
• Standby Time : 65 Hours
• Battery Size : 400mAh
• Charge Time : 2 Hours

Included

• 1 x Wireless Headphone
• 1 x USB to USB-C charging cable
• 1 x 3.5mm Audio cable

Battery Charge:

This wireless headphone is powered by a rechargeable Li-ion battery.
When the battery is low the headphones will emit a sound to remind you to recharge it.

1. Insert USB charging cable into a 5V 1A USB port for charging.
2. Connect the USB charging cable with the USB-C port on the headphone.
3. The LED indicator turns red to show battery is charging.
4. The LED indicator turns off when battery is fully charged.
5. It takes about 2 hours to fully charge the headphone.

How to use this Headphone

A. Power ON/OFF

B. Pairing the Headphone

1. To enter pairing mode, ensure headphone is OFF, then press and hold the power button (1) for 5 seconds until the LED indicator flashes blue and red, and a voice prompt ‘Pairing Mode’can be heard.
2. On your device search for the pairing name: LE WIRE FREE
   This applies to all colours.
   Once connected the voice prompt ‘Connected’ can be heard.
   (Note: The headphones can be connected directly via the 3.5mm audio cable).

Overview

1. Power button
2. USB-C charging port
3. LED indicator
4. 3.5mm Audio cable port
5. Built-in microphone
6. Decrease volume/Previous track
7. Play/Pause/Answer call/End call/Reject call
8. Increase volume/Next track

Function & Operation

• Pause: Press button (7)

• Play: Press button (7)

• Next Song: Press and hold button (8)

• Previous Song: Press and hold button (6)

• Volume Up: Press button (8)
  When the volume is adjusted to maximum you will hear an indication tone

• Volume Down: Press button (6)

• Answer Call: Press button (7)

• End Call: Press button (7)

• Reject Call: Press and hold button (7) for 2 seconds

• Voice Activation: Press and hold button (7) for 3 seconds until activated

• Music/Gaming: Press button (7) twice in

• Mode: quick succession

Modes – Gaming/Music

• This headphone is equiped with dual modes – gaming and music.
• To switch between modes, press (7) twice and you will hear a voice prompt signaling which mode you are in.
• Gaming mode – has lower latency than music mode.
• Music mode – has higher focus on sound quality.

Liquid Ears™
PO Box 5658 Brendale QLD Australia 4500
Customer Support 1800 812 261
www.liquidears.com
DESIGNED IN AUSTRALIA

Continuous use at full output may damage hearing.
Liquid Ears is a registered trademark.

Read User Manual Online (PDF format)

Download This Manual (PDF format)

Download this manual  >>