NWEAR SCD20 Charging Cradle for WD4 User Guide
- June 12, 2024
- NWEAR
Table of Contents
NWEAR SCD20 Charging Cradle for WD4 User Guide
Installations Instructions
-
Remove the screws and the metal plate.
-
Take out the expand DC plug and put it as shown.
-
Put the DC plug into another cradle
-
Install the screws as shown.
Support information
- Do not charge in direct sunlight or humid environment. If the power adapter is faulty, please contact the manufacturer to replace it with a new one.
- Do not incinerate or short-circuit the cradle, otherwise, danger may occur.
- Do not throw, drop or strike the cradle. Doing so might damage the internal components and result in malfunction.
- Only use the a soft cloth to clean the terminal. Cleaning it with wet cloth or benzene/thinner/ other volatile chemicals may deform and shorten the service life of the terminal’s shell
- For safety, please use the original adapter during charging. Please try to avoid charging for a long time. After fully charged, please disconnect the Power supply. pply.
LED in the cradle indicates the power status of the cradle. While the LED is
red, it means the power of the cradle is on.
- Indication of charging: LED on scanner
- Green LED on: Fully charged
- Red LED on: Charging i progress
Amaximum of 5 cradles can be combined.
For more information and technical support, please visit newland-
id.com/contact
Newland Europe BV
Role 25
4104 AV Calembour
The Netherlands
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>