NWEAR WD3-BS30 Bluetooth Badge Barcode Scanner User Manual

NWEAR WD3-BS30 Bluetooth Badge Barcode Scanner

WD3 BS30 PARTS

1. Press and hold the trigger button to power on.
2. In level mode, the scanner will enter standby mode after 5 seconds without operation.
3. Press and hold the trigger button for 15 seconds to power off.

LED indicator

1. LED off: standby.
2. Red LED on: charging.
3. Green LED on: full charge.
4. Red LED flashes slowly: battery lower than 10% Blue LED on: Bluetooth connected.
5. Blue LED flashes: Bluetooth disconnected.

Barcode programming

Enter/Exit setup

Good read beep

Operation mode

Clear pairing info on scanner

WLSCLP Clear pairing info on scanner.

Erminating character suffix

Enable terminating character suffix.

Set terminating character to CR carriage return.

Set terminating character to CRLF (OxOD, OxOA .Disable terminating character suffix.

Scan mode

CONTINOIS MODE

Factory defaults Restore all factory defaults. For more information,

please visit www.newland-id.com 

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>