KENWOOD CA-PLT14SG Amplifier Mounting Plate Instruction Manual
- June 12, 2024
- KENWOOD
Table of Contents
KENWOOD CA-PLT14SG Amplifier Mounting Plate
Product Information
- Product Name: CA-PLT14SG
- Manufacturer: JVCKENWOOD Corporation
- Maximum Dimension for Amplifier Mounting: 8.5 W x 7 D x 2 H (216mm x 178mm x 51mm)
Product Usage Instructions
- Place the CA-PLT14SG plate over the top of the radio.
- Locate and pull up each wire harness from the black plate using the factory Christmas tree fasteners.
- If your bike has a factory GPS, relocate the small square antenna just behind the voltmeter.
For updated information, including the latest Instruction Manual, please visit
the following website: https://manual.kenwood.com/en_contents/search/
Important Notes
©2023 JVCKENWOOD Corporation. All Rights Reserved. KENWOOD® and eXcelon® are
registered trademarks of JVCKENWOOD Corporation. Harley-Davidson®, Electra
Glide®, Road Glide®, Street Glide®, Ultra Classic®, Tri Glide®, CVO™, Screamin
Eagle® and Tour-Pak® are trademarks or registered trademarks of Harley-
Davidson, Inc. and/or its affiliates and if used or implied are for reference
only. There is no affiliation between Harley-Davidson, Inc. and/or its
affiliates and JVCKENWOOD Corporation and/or its affiliates. All other
trademarks are the property of their respective owners. Specifications subject
to change without notice.
Installation procedure
-
Over the top of the radio, pull up to release each wire harness from the black plate via the factory “Christmas tree” fasteners. If your bike has factory GPS, the small square antenna will need to be relocated just behind the voltmeter as shown in Fig 1.1 below.
The white circle shows the new location for the GPS Antenna if your bike came factory equipped with this feature.
-
Remove the four factory T-20 “Torx” screws that go through the top of the black plate and into the top of the radio. Set these screws aside for now.
-
Sit the main amplifier plate over the top of the radio, noting the 4 holes in the plate will line up with the 4 holes left by the factory screws just removed. The factory screws will now go through the main mounting plate, through the black plate over the top of the radio, and into the top of the radio.
-
Locate the Velcro® that came in the box and stick it to the bottom plate of the amp being installed. You can now “stick” the amp to the mounting plate just installed. Depending on the amp you are installing, you can use the “tabs” on the CA-PLT14SG to re-secure the wire harnesses that were held in place using the “Christmas Tree Fasteners.”
For updated information (the latest Instruction Manual, etc.), please visit
the following website:
https://manual.kenwood.com/en_contents/search/
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>