BRESSER 7009992 Thermo-Hygrosensor 3CH 433MHz Instruction Manual
- June 4, 2024
- BRESSER
Table of Contents
Thermo-Hygrosensor 3CH
433MHz
Art. Nr.: 7009992
Instruction Manual
General Warning
DANGER!
This device contains electronic components which operate via a power source
(power supply and/or batteries). Do not let children use the device while
unattended. Only use the device as described in the manual, otherwise, you run
the risk of an electric shock.
Children should only use the device under adult supervision. Keep packaging
material, like plastic bags and rubber bands, out of the reach of children, as
they pose a choking hazard.
Keep batteries out of the reach of children. Make sure you insert the
batteries correctly. Empty or damaged batteries could cause burns if they come
into contact with the skin. If necessary, wear adequate gloves for protection.
**DANGER!
Do not expose the device to high temperatures. Use only the recommended
batteries. Do not short-circuit the device or batteries, or throw them into a
fi re. Excessive heat or improper handling could trigger a short-circuit, a fi
re, or an explosion!
NOTE! Do not disassemble the device. In the event of a defect, please
contact your dealer. The dealer will contact the Service Centre and can send
the device in to be repaired, if necessary.
Use only the recommended batteries. Always replace weak or empty batteries
with a new, complete set of batteries at full capacity. Do not use batteries
from different brands or with different capacities. The batteries should be
removed from the unit if it has not been used for a long time.
NOTES ON CLEANING
Separate the device from the power supply or remove the batteries before
cleaning.
NOTE!
Only use a dry cloth to clean the exterior of the device. Do not use any
cleaning fl uid to avoid damaging the electronics.
SCOPE OF DELIVERY
Outdoor sensor, instruction manual
Batteries required (not included): 2 pcs. Batteries (1.5V, type AAA)
FEATURES OF THE REMOTE UNIT**
A DISPLAY (ON THE FRONT SIDE)
Displays temperature, humidity, current channel, and low
battery warning symbol [ ].
B WALL MOUNT
For mounting the sensor on walls.
C SET THE TRANSMISSION CHANNEL (1-3)
Input channel for the weather station. Set the channel
before inserting the batteries.
D TX (TEST)
TEST key transmits the current measured values.
E °C / °F – BUTTON
°C/°F button switches between Celsius (°C) and Fahrenheit (°F).
F BATTERY COMPARTMENT
The unit requires 2 pcs. UM-4 or “AAA” 1.5V batteries
G STAND
For positioning the device on a fl at the surface.
FIRST OPERATION
- Open the battery compartment cover.
- Set the desired channel with the switch. If you are using only one transmitter, please leave the selection at „1“.
- Insert 2 new LR06 or „AA“ 1.5V batteries observing correct polarity.
- Close the battery compartment cover and set the unit in the desired location. Although the outdoor sensor is weatherproof, it should not be placed in places exposed to direct sunlight, rain or snow.
TIPS FOR SETTING UP:
Please follow the instructions below to ensure optimum operation of the
equipment:
- Assign each external transmitter unit its own channel.
- Place the receiver unit and transmitter unit within 1 meter of each other and activate the manual search for available signals from all connected outdoor sensors on the main unit (weather station not included with delivery).
„Batteries empty“ indicator
When batteries are nearing depletion, the symbol [ ] is displayed on the
sensor and weather station.
DISPOSAL
Dispose of the packaging materials properly, according to their types, such as
paper or cardboard. Contact your local waste-disposal service or environmental
authority for information on the proper disposal.
Do not dispose of electronic devices in the household garbage! As per the
Directive 2002/96/EC of the European Parliament on waste electrical and
electronic equipment and its adaptation into German law, used electronic
devices must be collected separately and recycled in an environmentally
friendly manner.
In accordance with the regulations concerning batteries and rechargeable
batteries, disposing of them in normal household waste is explicitly
forbidden. Please make sure to dispose of your used batteries as required by
law — at a local collection point or in the retail market. The disposal of
domestic waste violates the Battery Directive.
Batteries that contain toxins are marked with a sign and a chemical symbol.
¹battery contains cadmium
²battery contains mercury
³battery contains lead
EC DECLARATION OF CONFORMITY
Hereby, Bresser GmbH declares that the equipment type with part number:
7009992 is in compliance with Directive: 2014/53/EU. The full text of the EU
declaration of conformity is available at the following internet address:
www.bresser.de/download/7009992/CE/7009992_CE.pdf
UKCA DECLARATION OF CONFORMITY
Hereby, Bresser GmbH declares that the equipment type with part number:
7009992 is in compliance with the relevant Directive on UKCA conformity. The
full text of the UKCA declaration of conformity is available at the following
internet address:
www.bresser.de/download/7009992/UKCA/7009992_UKCA.pdf
TECHNICAL DATA
Measurement
Temperature range: -40 – 70 °C (-4 – 158 °F)
Temperature steps: 0.1 °C/°F
Humidity range: 20 – 95% RH
Humidity steps: 1%
Transmission
Transmission frequency: 433,92 MHz
Maximum transmission power < 10mW
Transmission range: 50 meters (free fi eld)
Power supply
2x AAA 1.5V batteries (not included)
Bresser GmbH
Gutenbergstr. 2 FB
DE-46414 Rhede Germany
Service:
Web:www.bresser.de/weather
E-Mail:service@bresser.de
www.bresser.de/start/bresser
Turn sheet for german version · Deutsche Fassung umseitig
Documents / Resources
|
BRESSER 7009992 Thermo-Hygrosensor 3CH
433MHz
[pdf] Instruction Manual
7009992 Thermo-Hygrosensor 3CH 433MHz, 7009992, Thermo-Hygrosensor 3CH 433MHz,
Hygrosensor 3CH 433MHz
---|---
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>