REVMAX AS68RC/AS69RC Signature Series Transmission Installation Guide
- June 12, 2024
- REVMAX
Table of Contents
AS68RC/AS69RC Signature Series
Installation Instructions
AS68RC/AS69RC Signature Series Transmission
The installation and drive learning process will take anywhere from 2-3 days.
Towing, hauling and or rough driving cannot be done during this time!
***Prior to removal of original transmission set your programmer or tuner to
STOCK power level! All relearn procedures will be done at stock power levels,
never turn up the power during relearn.
Correct transmission fluid levels are CRITICAL and hard to obtain correctly.
Fluid must be Mopar AS fluid or warranty is voided.
Connect to TCM with Chrysler WITECH or other capable scanner and perform
transmission relearn process. Be sure that the scanner has successfully
performed the relearn procedure. If TC does not successfully relearn, stop
immediately turn off engine and call RevMax prior to proceeding. Vehicle
cannot be driven anywhere until the relearn is completed. Not even around the
block or in the parking lot!
Initial Drive Learn Process
You will now take the vehicle out for the initial test drive, do not exceed
30% throttle or 2000RPM. Allow transmission to shift all the way up to sixth
gear AND back own to first at least 25 times. If full power is given,
immediate transmission failure will occur and you will be responsible for
repair charges.
Begin the initial drive learn cycle. You must keep throttle below 50% at all
times during this cycle. Drive the vehicle for a MINIMUM of 2-3 days. The
truck must be allowed to rest overnight and go from HOT to COLD engine and
transmission temperatures. During this time period it is best to have a
MINIMUM of 200 miles STOP AND GO driving. Highway driving does not count and
will not drive learn the transmission.
revmaxconverters.com
877.780.4334
4400-2 Westinghouse Blvd.
Charlotte, NC 28273
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>