Ruijie RG-RAP6202(G) Access Point User Manual

June 12, 2024
RuiJie

Ruijie RG-RAP6202(G) Access Point

Package Contents

Management software WSP-RAP6202(G) is installed on the access point upon delivery .

Connecting the Access Point to the Internet

The access point can also be powered by a DC power adapter (12 V/1.5 A). The adapter should be purchased separately.

Mounting the Access Point

Wall Mount
  1. Secure the mounting plate on the wall using expansion bolts.
  2. Install the access point and the connecting rod to the mounting plate using M8?0 screws.
Vertical Pole Mount
  1. Secure the mounting plate to the vertical pole by threading two clamps through the mounting plate.
  2. Install the access point and the connecting rod to the mounting plate using M8?0 screws.
Horizontal Pole Mount
  1. Secure the mounting plate to the horizontal pole by threading two damps through the mounting plate.
  2. Install the accass point and the connecting rod to the mounting plate using M6″20 screws.

Installing the Cable Gland

  1. Trim an Ethernet cable according to the distance between the access point and the power supply.
  2. Insert the unterminated end of the Ethernet cable through part D, C and B in sequence.
  3. Install an RJ45 connector on the unterminated end of the Ethernet cable using an Ethernet cable installation tool.
  4. Insert the RJ45 connector into the LAN1/PoE/uplink port of the access point, and tighten part B, C and D in sequence.
  5. If you want to install the cable gland without an Ethernet cable threaded through it, insert the waterproof rubber rod into the washer (rubber gasket), and tighten part B, C and D in sequence.
  6. Make sure to cap the DC port and the reset button with clean waterproof caps and insert them into the slot of connecting rod.

Configuring the Access Point

Method 1 (Recommended)
Scan the QR-code in the manual or on the device to download Ruijie Cloud App, and follow the guide on App to configure the network.

Method 2
Connect to the Wi-Fi network (default SSID: @Ruijie-mxxxx), or plug an Ethernet cable into the LAN port of the access point, and visit http://10.44.77.253. If you want to configure a specific device, please plug an Ethernet cable into its LAN port and visit http://10.44.77.254.

Note:
This equipment is restricted to indoor operation in 5.15-5.35GHz for Hong Kong.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals