Disnep GLOW N GO Brilliant LED Bike Light User Manual

June 12, 2024
Disnep

Disnep GLOW N GO Brilliant LED Bike Light User Manual

DISTRIBUTED BY QUEST USA CORP.
LIMITED – SUITE 1, 3RD FL 11-12 ST JAMES
SQUARE LONDON SW1Y 4LB
© GOIJOY & IJOY are registered trademarks of QUEST USA CORP.

All other trademarks and trade names are property of their respective owners.
Designed by GOIJOY & IJOY in New York.
All rights reserved QUEST USA CORP.

Made in China.

FIG 2.JPG

BATTERY CAUTION

The battery used in this device may present a risk of fire, explosion or chemical burn if used incorrectly. Never use or charge the battery if it appears to be leaking, discolored, deformed or in any way abnormal. Never disassemble the unit or attempt to remove the battery as that could cause leakage of alkaline solution or other electrolytic substances. Never expose the battery to any liquid. Never expose the battery to excessive heat such as direct light or fire. Always keep the battery out of the reach of infants and small children.

TIP: Must use a formal manufactured certified charger. If the bike light has not been used for a significant amount of time, please make sure to charge before using the product.

BATTERY DISPOSAL

Please do not attempt to change the battery yourself. If the battery has died, you should follow the disposal instructions listed here. Never dispose of used batteries/electronics with ordinary solid wastes. Always dispose of used batteries/electronics in accordance with the prevailing community regulations that apply to the disposal of batteries/electronics. If there are no local regulations concerning battery/electronics disposal, please dispose of the device in a waste bin for electronic devices. Many electronics retailers now recycle batteries and other electronic components at no charge.

DEVICE FUNCTIONS

KEY FUNCTIONS & INSTRUCTIONS

  • To turn on the light:
    Hold down the side button, and continue to lightly touch the button to switch between modes.

  • Touch the side button to cycle through each light mode.
    Each light mode goes as follows: flash -> slow flash -> alarm flash -> strong light -> weak light

  • To turn off the light:
    Long press the switch to enter the OFF state after 2 seconds.

Bike Light x 1
Velcro Strap x 1
20cm USB Cable x 1

  1. Insert the nylon mounting belt through the bike light
  2. Loop the belt through the bike rode and pass one section of the strap through the square hole at the other end.
  3. Adjust the tightness of the belt according to the diameter of the rod and adjust the bike light on the rod your liking.

IMPORTANT REMINDERS

This device can ONLY be charged by 5V adapter/ USB ports only. Quick charging devices over 5V may cause heat and fire.

OTHER IMPORTANT SAFETY INFORMATION

Disposal of old electronic & electronic equipment (Applicable in the European Union and other European Counties with separate collection systems) The trash can symbol (seen in this manual) on the production indicates that this product shall not be treated as household waste. Instead it shall be handed over to the applicable collection point for recycling of electronic equipment. By ensuring this product is disposed of correctly, you will help prevent potential negative consequences for the environment and human health, which could otherwise be caused by inappropriate waste handling. For more detailed information about this product, please contact your local household waste disposal service or the shop where you purchased this item.

Read More About This Manual & Download PDF:

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals