SEVERIN SM 3586 Induction Milk Frother Instruction Manual

: June 12, 2024
: SEVERIN

Table of Contents

Induction-type milk frother
Familiarisation
- Important safety instructions
Operation
Fill amounts
- Preparation
- Preparation instructions
Trouble shooting
References
Read User Manual Online (PDF format)
Download This Manual (PDF format)

SEVERIN SM 3586 Induction Milk Frother Instruction Manual

Induction-type milk frother

Dear Customer,
Before using the appliance, read the following instructions carefully and keep this manual for future reference. The appliance must only be used by persons familiar with these instructions.

Connection to the mains supply
The appliance should only be connected to an earthed socket installed in accordance with the regulations. Make sure that the supply voltage corresponds with the voltage marked on the rating label of the appliance. This product complies with all binding CE labelling directives.

Familiarisation

Product Description

Lid with insert
Milk container with handle
Stirring tool – smooth
Stirring tool cover
Stirring tool – serrated
Power cord with plug
Wind-up cable storage (on underside)
Rating label (on underside)
On/Off button
Easy-select rotary control
Base
Light ring

Important safety instructions

In order to avoid hazards, repairs to this electrical appliance or its power cord must be carried out byour customer service. If repairs are needed, please contact our customer service department by phone or email (see appendix).
Before cleaning the appliance, ensure it is disconnected from the power supply and has cooled down completely.
Detailed information on cleaning can be found in the section Cleaning and care.
Do not immerse the base in liquids, and do not clean it under running tap water.
Caution: The electrical connection in the base must be protected at all times against possible spillage of liquids.
The milk frother must only be used onits designated base.
Caution: Any misuse can cause severe personal injury.
Always use the milk container handle, as the surface may be hot during and after operation.
The appliance is not intended to be operated by means of an external timer or separate remote-control system.
This appliance is intended for domestic or similar applications, such as the
staff kitchens in shops, offices and other similar working environments,
agricultural working environments,
by customers in hotels, motels etc. nd similar accommodation,
in bed-and breakfast type environments.
This appliance may be used by children (at least 8 years of age) and by persons with reduced physical, sensory or mental capabilities, or lacking experience and knowledge, provided they have been given supervision or instruction concerning the use of the appliance and fully understand all dangers and safetyprecautions involved.
Children must not be permitted to play with the appliance.
Children must not be permitted to carry out any cleaning or maintenance
work on the appliance unless they are supervised and at least 8 years ofage.
The appliance and its power cord must be kept well away from children under 8 at all times. ∙ Caution: Keep any packaging materials well away from children – such materials are a potential source of danger, e.g. of suffocation.
Every time the appliance is used, the main body including the power cord as well as any attachment fitted should be checked thoroughly for any defects. Should the appliance, for instance, have been dropped onto a hard surface, or if excessive force has been used to pull the power cord, it must no longer be used: even invisible damage may have adverse effects on the operational safety of the appliance.
This appliance is solely designed for heating up and frothing milk, hot chocolate and cocoa. Do not put any other type of liquid or solid food in the container.
Do not leave the milk frother unattended while in use.
Always observe the min and max level marks inside the milk container for each application.The protrusion in the bottom of the container (min. level mark) must be covered by the milk. If there is not enough milk, the appliance may overheat.
Overfilling the container may cause danger if frothing milk is forced out.
Caution: The lid must always be fitted during operation.
Do not cover the ventilation slots at the rear of theappliance.
The appliance may only be used with the original accessory parts provided by the manufacturer.
The appliance must always be set on a firm, level surface.
Do not allow the appliance or its power cord to come into contact with open flames or any hot surfaces such as hot-plates.
Do not allow the power cord to hang free; the cord must be kept well away from hot parts of the appliance.
Always remove the plug from the wall socket
in case of any malfunction,
after use,
before cleaning the appliance.
When removing the plug from the wall socket, never pull on the power cord; always grip the plug itself.
No responsibility is accepted if damage results from improper use, or if these instructions are not complied with.

Before using for the first time

Remove any remaining packaging materials and promotional stickers, and check that all components are present.
Before the appliance is used for the first time, or after extended periods of non-use, it should be thoroughly cleaned as described in the section Cleaning and care.

Wind-up power cord storage

There is a power-cord storage compartment in the base.
Unwind the cord to the required length before use.
Wind up the power cord again after use.

Operation

Lid

The lid must always be fitted during operation.
To add ingredients during operation, turn and then take off the lid insert.
For storage, the smooth stirring tool can be fitted to the lid insert.

Light ring Red

A function with heating is selected.
Blue
A function without heating is selected.

Steady light
Preparation is in progress.
Flashing red or blue
The unit is waiting for an input, preparation is complete, or an error has occurred (see Trouble shooting at the end of the instructions).

Selecting the stirring tool

The following stirring tools are available:

smooth
smooth
serrated with cover

Beverage	Function	Stirring tool
Milk froth	Frothing
Hot milk	Heating
Hot chocolate/ cocoa	Heating

Fill amounts

MIN
minimum quantity 120 ml – the protrusion must be covered
MAX Frothing
maximum quantity of milk 350 ml (lower max mark
MAX Stirring and heating
maximum quantity 700 ml (upper max mark)

Preparing the appliance

Remove the lid from the milk container.
Fit the selected stirring tool in the milk container and push it down: ensure it is seated on the lower part of the protrusion.
Put the required amount of milk into the container.
Place the lid on the container.
Insert the plug into the wall socket.
Place the milk container onto the base

Preparation

Turn the rotary control to turn the appliance on and select the required function:
cold frothing
warm frothing
or heating milk 45 to 65 °C

hot chocolate / cocoa

Press to start the preparation.

Note:
If the appliance is not in stand-by mode, the button must be pressed twice.

The programme starts.
To prepare cocoa and hot chocolate, fill in the desired amount of cocoa powder or chocolate (see Preparation instructions).
Once processing is complete, the heating and stirring process stops automatically.
You can now remove the milk container from the base.
Pour out the prepared food, or use a suitable spoon to take off the milk froth. Do not leave any residual amounts in the container.
Detach the power cord from the wall socket after use.
Always allow the appliance to cool down first, and then clean it, before starting a new cycle.

Preparation instructions

Milk froth:

We recommend using milk with a high protein content. For best results, the milk should be taken from the refrigerator immediately before frothing.
To achieve a thicker froth, go through a cold-frothing cycle first, followed by a hot-frothing cycle.

Hot chocolate / cocoa:

To prepare drinking chocolate from milk and chocolate or cocoa.
Grate the chocolate finely before preparation.
Alternatively, break down the chocolate to pieces of 5 x 4 cm minimum (but not any smaller). Caution: Do not fill in melted chocolate!
Fill in the chocolate / cocoa only after the programme has started, when the milk is already being stirred. Otherwise, the stirring tool could jam.
We recommend using the following amounts of chocolate:
200 ml milk approx. 15-20 g
350 ml milk approx. 30-35 g

Interrupting a cycle

The heating or stirring process may be stopped by pressing at any time.

Automatic switch-off

The appliance switches off automatically two minutes after non-use.

Cleaning and care

Before cleaning the appliance, ensure it is disconnected from the power supply and has cooled down completely.
To avoid the risk of electric shock, do not clean the base or the power cord with water and do not immerse them.
The base can be cleaned with a soft, damp cloth and some detergent.
The milk container, stirring tools and lid should be cleaned after each cycle of use with hot water and a little detergent, or in the dishwasher. If necessary, the serrated stirring tool may be taken off and cleaned with a suitable brush.
Wipe all parts thoroughly dry.
Do not use abrasives or harsh cleaning solutions.

Disposal

Devices marked with this symbol must be disposed of separately from your household waste, as they contain valuable materials which can be recycled. Proper disposal protects the environment and human health. Your local authority or retailer can provide information on the matter.

Trouble shooting

Problem	Cause	Remedy
Milk is not frothing / The light ring flashes red and blue	Missing stirring
tool	Fit stirring tool
The motor jams	Detach the milk container, remove the blockage, re-start the

appliance
Light ring is flashing| Milk container was removed during operation| Fit the milk container and re-start the appliance
Appliance doesn’t start| The unit was not in stand-by mode when was pressed| Press again

Should you be unable to solve the problem using the table, please contact our Customer Service. The contact data can be found in the appendix to this manual.

Costumer Support

SEVERIN Elektrogeräte GmbH
Röhre 27
D-59846 Sundern
Tel +49 2933 982-0
Fax +49 2933 982-1333
information@severin.de