Signature Hardware 1.8GPM Wall Mounted Pot Filler Faucets Instruction Manual
- June 12, 2024
- Signature Hardware
Table of Contents
1.8GPM 6.8L/min
WALL MOUNTED POT FILLER FAUCETS
Instruction Manual
1.8GPM Wall Mounted Pot Filler Faucets
You may need
For easy installation of
your faucet you will need:
To READ ALL the instructions completely before beginning.
To READ ALL warnings, care, and maintenance information.
Application
Faucet are designed for delivering cold water from a main supply.
Faucet can be positioned above sinks or stoves and the articulated nature of
the spout enables the outlet to be conveniently positioned above pots / pans
as required.
Installation
Note:
When installing on plasterboard walls (not solid walls) it must be assured
that an appropriate reinforcement is in place to ensure sufficient strength.
Flush pipes thoroughly!
Cleaning and Care
Care should be given to the cleaning of this product. Although its finish is
extremely durable,
It can be damaged by harsh abrasives or polish.
To clean, simply wipe gently with a damp cloth and blot dry with a soft
towel.
Notice:
Simple on/off control by rotating handle 90 (1/4 turn)
Shut off both handle cartridges when not in use or left unattended. Improper
use or inadequate drainage below faucet may cause water damage.
Notice:
Cold water connection only
1″ recommended hole size
1/2″ IPS inlets
WARNING: Connect to Cold Water Only. Wrap plumber tape around pipe
threads
Connect to 1/2″ IPS supply line. Push flange on pot filler, mark locating hole
on wall 
Drill holes and insert
plugs 
Wrap plumber tape (1)
around pipe threads.
Install the gasket (2) and the flange (3) using the 4 screws
provided.
Place flange trim (1)
onto the faucet .
Thread faucet ontopipe.
Tighten securely, but do not overtighten. Screw on pot filler
Screw in screw by using an 1.5mm allen wrench to fasten pot filler to flange .
Remove aerator (1) and turn faucet handles (2) to the full on position.
Turn on cold water supplies and flush water lines for one minute.
Important: This flushes away any debris that could cause damage to
internal parts.
Check all connections at arrow for leaks.
Re-tighten if necessary, but do not overtighten.
With 1.8 gpm are compliant with
California water effi ciency regulations, Complies with California Proposition
65 and with the Federal Safe Drinking Water Act.
In areas with extremely low water pressure causing the faucet water flow to be
unsatisfactory, replace the aerator to improve the water flow in the
faucet.
If faucet leaks out of spout or handle – Replace valve cartridge
(4).
Remove handle cap(3), stick(1)and screw (2). Unscrew and replace valve
cartridge, 1.5 mm hex. Assemble in reverse order. Line up handles with valves
in closed position before pushing handles into place.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>