FDF RaceShop V2 350Z Regular Mantis Kit Installation Guide

June 4, 2024
FDF RaceShop

FDF RaceShop V2 350Z Regular Mantis Kit Installation Guide
FDF RaceShop V2 350Z Regular Mantis Kit

Assembly instruction

Fully Assembled view of the 350z mantis kit is shown for the left side of the car
Assembly instruction

  1. Upper Control Arm
  2. Lower control arm
  3. Tierod Assembly

Bolt check regularly, take note of the orientation of all the components in this view.

do not exceed the rod ends adjustments, each rod end should have a minimum of 1 to 1.5x the diameter of the joint. (example, a ¾-16 rod end needs to have approx. .75-1.125” inside of the arm at a minimum, this is 12-18 threads)

(knuckle adaptor) may require some removal of material on the knuckle, remove material until the adaptor sits flat. Adjust the Ackerman using the 3 positions available (+2, 0, -2)

Offset Rack spacer , if the steering rack is in the factory position, the rack spacer is designed to move the inner tierod forward 32mm. (the other 2 holes are only for if the rack is relocated) use red locktite on the rack bolt and torque to factory spec.

Alignment Recommendations
Caster- 8.5 + or – .5
Camber -5 + or -1.0
Toe 0-1/8th out
Wheel size recommendation
18×9 +10 offset (close to this size will work well)

For Racing Use only
Icon

Not For Road Use

Support

Must be installed by a licensed professional

  fdfraceshopcustomerservice@gmail.com
 +1(613)243-8859

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals