VISUAL COMFORT CHD 2165 Darlana 3/4 Wall Sconce Instruction Manual
- June 12, 2024
- VISUAL COMFORT
Table of Contents
VISUAL COMFORT CHD 2165 Darlana 3/4 Wall Sconce
Product Information
Product Name: Darlana 3/4 Wall Sconce
Item Number: CHD 2165
Manufacturer : CM
Certification : Listed by Intertek
Power Supply : 120V AC
Product Usage Instructions
- We highly recommend that the installation of this lighting fixture be carried out by a licensed electrician.
- Before starting the installation process, switch off the main electrical supply from the main fuse box or circuit breaker.
- Inspect the item carefully before attempting to install. If you notice any damage or obvious defects, do not proceed with the installation. Please note that once the item has been installed, it cannot be returned.
- Carefully unpack each piece in the top layer of packing before removing. Retain all packing material until inspection and installation are complete.
- Remove all parts from the box.
- Loosen the side screws (F) to remove the mounting plate (D) from the fixture body (G).
- Drill four holes on the wall, ensuring that the hole distance matches the mounting plate (C) holes.
- Knock the anchors (B) into the wall holes.
- Affix the mounting plate (D) onto the outlet box and secure it with the provided mounting screws (E). Then, secure the screws (C) to the anchors (B).
- Connect the hot wire (BLACK) from the fixture to the hot wire from the outlet box.
- To clean the fixture, use a dry, soft cloth. Do not use harsh abrasives or chemical agents.
Darlana 3/4 Wall Sconce
Item # CHD 2165
WE RECOMMEND INSTALLATION OF THIS LIGHTING FIXTURE BE DONE BY A LICENSED
ELECTRICIAN.
**WARNING*** SWITCH OFF THE MAIN ELECTRICAL SUPPLY FROM THE MAIN FUSE
BOX/CIRCUIT BREAKER BEFORE INSTALLATION.
INSPECT ITEM CAREFULLY BEFORE ATTEMPTING TO INSTALL. IF THERE IS ANY DAMAGE OR
OBVIOUS DEFECT. DO NOT INSTALL.
ITEM MAY NOT BE RETURNED ONCE IT HAS BEEN INSTALLED.
NOTE** : CAREFULLY UNPACK EACH PIECE IN TOP LAYER OF PACKING PRIOR TO
REMOVING. RETAIN ALL PACKING MATERIAL UNTIL INSPECTION AND INSTALLATION ARE
FINAL.
ASSEMBLY INSTRUCTIONS **
**
- Carefully remove all parts from the box.
- Remove the mounting plate (D) from the fixture body (G) by loosening side screws (F).
- Drill 4 holes on the wall and make sure the hole distance will match to the mounting plate (C) holes.
- Knock the anchors (B) into the wall holes.
- Affix mounting plate (D) onto the outlet box and secure with mounting screws (E), then secure the screws (C) to the anchors (B).
- Connect the hot wire (BLACK) from the fixture to the hot wire from the outlet box (usually BLACK). Fasten them together with a plastic wire connector (A) provided and wrap the connection with electrical tape.
- Connect the neutral wire (WHITE) from the fixture to the wire from the outlet box (usually WHITE). DO NOT REVERSE THE HOT AND NEUTRAL CONNECTIONS OR SAFETY WILL BE COMPROMISED.
- Connect ground wire from the fixture (bare copper) to ground wire from the outlet box (usually green or copper in color). IS IMPERATIVE THAT THIS FIXTURE BE GROUNDED.
- Attach fixture body (G) onto the mounting plate (D) and secure with side screws (F).
- Insert bulb (not included) into the socket.
- Installation is complete, turn on power at fuse or circuit breaker.
***Clean with a dry, soft cloth only. Use no harsh abrasives or chemical agents.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>