ricoo TS4211 Monitor Table Mount with Elevation Instruction Manual
- June 12, 2024
- ricoo
Table of Contents
Assembly Instructions
MAXMAX
8kg8kg
17.6lbs
Warning: Do not exceed listed load weight. Property damage oder serious injury may occur!
TS4211 Monitor Table Mount with Elevation
Please check BEFORE installation distance between VESA mounting holes on your
display!
This screen mount supports VESA hole distance in the minimum and maximum
distance ranges given above.
VESA – Hole distance = Distances between the mounting holes on the screen
back.
Scope of delivery
We recommend using a professional level.
The numbering on the plastic bag may differ / missing completely!
NOTE: READ THE ENTIRE INSTRUCTION MANUAL BEFORE YOU START INSTALLATION
AND ASSEMBLY
Please note: Images in these assembly instructions are only technical
presentation of the product. Actual product design may vary minimally.
Do not begin the installation until you have read and understood all the
instructions and warnings contained in this installation sheet. If you have
any questions regarding any of the instructions or warnings, please contact
your local distributor. This product was designed to be installed and used
ONLY as specified in this manual. Improper installation of this product may
cause damage or serious injury. This product may only be assembled / installed
by the technical staff. Make sure that the supporting surface will safely
support the combined weight of the equipment and all attached hardware and
components. Always use an assistant or mechanical lifting equipment to safely
lift and position the equipment. Make sure that before and after the
installation of the product neither you nor somebody else can be injured and
other objects can be damaged. In case of doubt request for help from an
expert. This product is intended for indoor use only. Using this product
outdoors could lead to product failure and personal injury. Tighten screws
firmly, but do not over tighten. Over tightening can cause damage the items,
this greatly reduces their holding power.
By reason of large television construction types on the market, we can’t
adjust our screen installation materials for each screen type. Therefore it is
possible that the screws which are numerously delivered don’t fit with your
TV/Monitor. We ask for your understanding that we can’t cover up all
possibilities of many screen types.
When mounting on the wooden beams wall, make sure that the fastening screws
are anchored in the center of the beams. It is highly recommended to use a
beamfinder. If your walls have a special demand of materials, we advise you to
ask in an expert shop for a suitable acquirement of the installation
materials.
Use the matching screws and spacers for your display.
E-Mail: support @ ricoo.de
www.ricoo.eu
E.N.Z. Engineering GmbH
Salzmatten 6
79341 Kenzingen
(Germany)
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>