RICOO TS3411 Monitor Table Mount Instruction Manual
- June 12, 2024
- ricoo
Table of Contents
RICOO TS3411 Monitor Table Mount
Product Information
- Manufacturer: E.N.Z. Engineering GmbH
- Address: Salzmatten 6, 79341 Kenzingen, Germany
- Product Model: TS3411
- Maximum Load Capacity: 8kg (17.6lbs)
- VESA Hole Distance Supported: 75mm x 75mm, 100mm x 100mm
Product Usage Instructions
- Before installation, check the distance between the VESA mounting holes on your display.
- This screen mount supports VESA hole distances within the minimum and maximum ranges specified above.
- Make sure not to exceed the listed load weight to avoid property damage or serious injury.
- Follow the assembly instructions provided in the manual:
- Mount A (x1), B (x1), C (x1), and D (x1) using the respective screws M-A (x4) and M-B (x4).
- Attach E (x2) and F (x3) to the assembled parts.
- Insert G (x1) with a 4mm screw and H (x1) with a 6mm screw.
- Install I (x1) and M-C (x4) using D5 screws.
- Ensure that the distance between A and B is within the specified range of 40mm to 85mm, and the distance between E and F is within 10mm to 50mm.
- Once assembled, the product is ready for use.
If you have any further questions or need assistance, you can contact the manufacturer’s support via email at support@ricoo.de or visit their website at www.ricoo.eu.
Scope of delivery
INSTRUCTION
NOTE: READ THE ENTIRE INSTRUCTION MANUAL BEFORE YOU START INSTALLATION
AND ASSEMBLY
Please note: Images in these assembly instructions are only technical
presentations of the product. Actual product design may vary minimally. Do not
begin the installation until you have read and understood all the instructions
and warnings contained in this installation sheet. If you have any questions
regarding any of the instructions or warnings, please contact your local
distributor. This product was designed to be installed and used ONLY as
specified in this manual. Improper installation of this product may cause
damage or serious injury. This product may only be assembled/installed by the
technical staff. Make sure that the supporting surface will safely support the
combined weight of the equipment and all attached hardware and components.
Always use an assistant or mechanical lifting equipment to safely lift and
position the equipment. Make sure that before and after the installation of
the product neither you nor somebody else can be injured and other objects can
be damaged. In case of doubt request for help from an expert. This product is
intended for indoor use only. Using this product outdoors could lead to
product failure and personal injury. Tighten screws firmly, but do not over
tighten. Over-tightening can cause damage the items, this greatly reduces
their holding power. By reason of large television construction types on the
market, we can’t adjust our screen installation materials for each screen
type. Therefore it is possible that the screws which are numerously delivered
don’t fit with your
TV/Monitor. We ask for your understanding that we can’t cover up all
possibilities of many screen types.
BEFORE installation
Please check BEFORE installation distance between VESA mounting holes on your
display!
This screen mount supports VESA hole distance in the minimum and maximum
distance ranges given above.
VESA – Hole distance = Distances between the mounting holes on the screen
back.
ASSEMBLY
E.N.Z. Engineering GmbH
Salzmatten 6
79341 Kenzingen
(Germany)
E-Mail: support@ricoo.de
www.ricoo.eu
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>