ricoo TS9811 Dual Monitor Stand Tilt Swivel Instruction Manual
- June 12, 2024
- ricoo
Table of Contents
TS9811 Dual Monitor Stand Tilt Swivel
Instruction Manual
TS9811 Dual Monitor Stand Tilt Swivel
2 x MIN 1kg 2.2lbs ∼ MAX 9kg 19.8lbs
Warning: Do not exceed listed load weight. Property damage oder serious
injury may occur!
Please check BEFORE installation distance between VESA mounting holes on
your display!
This screen mount supports VESA hole distance in the minimum and maximum
distance ranges given above.
VESA – Hole distance = Distances between the mounting holes on the screen
back.
Scope of delivery
The numbering on the plastic bag may differ/missing completely!
NOTE: READ THE ENTIRE INSTRUCTION MANUAL BEFORE YOU START INSTALLATION AND
ASSEMBLY
Please note: Images in these assembly instructions are only technical
presentation of the product. Actual product design may vary minimally.
Do not begin the installation until you have read and understood all the
instructions and warnings contained in this installation sheet. If you have
any questions regarding any of the instructions or warnings, please contact
your local distributor. This product was designed to be installed and used
ONLY as specified in this manual. Improper installation of this product may
cause damage or serious injury. This product may only be assembled / installed
by the technical staff. Make sure that the supporting surface will safely
support the combined weight of the equipment and all attached hardware and
components. Always use an assistant or mechanical lifting equipment to safely
lift and position the equipment. Make sure that before and after the
installation of the product neither you nor somebody else can be injured and
other objects can be damaged. In case of doubt request for help from an
expert. This product is intended for indoor use only. Using this product
outdoors could lead to product failure and personal injury. Tighten screws
firmly, but do not over tighten. Over tightening can cause damage the items,
this greatly reduces their holding power.
By reason of large television construction types on the market, we can’t
adjust our screen installation materials for each screen type. Therefore it is
possible that the screws which are numerously delivered don’t fit with your
TV/Monitor. We ask for your understanding that we can’t cover up all
possibilities of many screen types.
When mounting on the wooden beams wall, make sure that the fastening screws
are anchored in the center of the beams. It is highly recommended to use a
beam finder. If your walls have a special demand of materials, we advise you
to ask in an expert shop for a suitable acquirement of the installation
materials.
| 
---|---
WARNING: Perform the tension-balance adjustment only after the screen
assembly! This operation must be carried out only with the Allen key!
Please keep the arm level during tension adjustment. Use a proper Allen key to
slightly loosen or tighten the adjustment screw according to the display
weight.
If display settles on its own, rotate adjustment screw towards the “+” symbol.
If display rises on its own, rotate adjustment screw towards the “-” symbol.
DURING THE LATER REMOVING OF THE DISPLAY MAKE SURE THE FRONT ARM IS ON TOP
BEFORE TAKING OFF THE DISPLAY!
Attention: The arm can shoot up upwards because of the gas pressure
spring! If you don’t pay attention you can be injured.
E.N.Z. Engineering GmbH
Salzmatten 6
79341 Kenzingen
(Germany)
E-Mail: support@ricoo.de
www.ricoo.eu
v.21.0
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>