VICTOR METRO VSRP-800 Dual Bluetooth Suitcase Turntable Instruction Manual

VICTOR METRO VSRP-800 Dual Bluetooth Suitcase Turntable

Product Information

The product is a turntable with built-in speakers. It has a frequency range of 2.40 GHz and a wireless range of up to 10  meters. The turntable supports three speeds: 33 1/3, 45, and 78 rpm. It has an auxiliary input and output, and the built-in speakers have a power output of 2 x 2 W. The product comes with an AC/DC adapter for power supply.

Product Usage Instructions

1. Before operating the product, make sure to read the manual completely and keep it for future reference.
2. Adjust the volume on your unit and device to the desired level.
3. To transport the turntable, follow these steps:
4. Place the protective cover over the phonograph head.
5. Put the arm in the support.
6. Secure the arm in place with the lock.
7. Do not place or operate the device near any other antenna or transmitter.
8. For technical support, contact Naxa at:
   • Address: 2320 East 49th St. Vernon, CA 90058
   • Phone: 866-411-6292
   • Website: http://www.naxa.com/supportcenter

CAUTION: To reduce the risk of fire or electric shock. do not expose this appliance to rain or moisture.

WARNING: Invisible laser radiation when open and interlock failed or defeated. Avoid direct exposure to laser beam.

This require a equipment safety is cona Class nection II to or double electrical earth. insulated electrical appliance. It has been designed in such a way that it does not
wastes Correct Disposal throughout of the EU. this_product To prevent This marking possible harm indicates to the that this environment product or should human not be health disposed from with uncontrolled other waste household disposal, recycle it responsibly to tems promote or the contact the sustainable retailer reuse where of the material product was resources. To purchased. return Tfley your can used take device, this productplease
for use the environmental return and safe collection recycling.sys

Important Safety Instructions

1. Read these instructions – All the safety and operating instructions should be read before this product is

2. Keep these instructions – The safety and operating instructions should be retained for future

3. Heed all warnings -All warnings on the appliance and in the operating instructions should be adhered to.

4. Follow all instructions -All operating and use instructions should be

5. Do not use this apparatus near water – The appliance should not be used near water or moisture – for example, in a wet basement or near a swimming pooli and the like.

6. Clean only with a <fry clo

7. Do not block any ventilation Install in accordance with the manufacturer’s instructions.

8. Do not install near any heat sources such as radiators, heat registers, stoves, or other apparatus (including amplifiers) that produce

9. Protect the power cord from being walked on or pinched particularly at the plugs, power outlets, and at the point where they exit from the apparatus.

10. Only use attachments/accessories specified by the

11. Use only with the cart, stand, tripod, bracket, or table specified by the manufacturer, or sold with the apparatus. ‘When a cart or rack 1s used, use caution when moving the cart/apparatus combination to avoid 1nJury from tip-over.

12. Unpfug the apparatus during lighting storms or when unused for long periods of

13. Refer all servicing to qualified personne Servicing is required when the apparatus has been damaged in any way, such as power supply cord or plug is damaged, liquid has been spilled or objects have fallen into the apparatus has been exposed to rain or moisture, does not operate normally, or has been dropped.

14. The mains plug is usedas disconnect device, the disconnect device shall remain readily

15. WARNING: To reduce the risk of fire or electric shock.,,, do not expose this apparatus to rain or moisture. The apparatus shall not be exposed to dripping or splashing and tha_t no objects Tilled with liquids, such as vases, shall not be placed on the apparatus.

16. The use of the equipment in mooerate

17. The ventilation should not be impeded by covering the ventilation openings with items, such as newspapers, tablecloths, curtains,

18. Do not place open flame sources, such as lighted candles, on the apparatus.

19. The symbol with—- i.n..d. icates AC

20. CAUTION, These servicing instructions are for use by qualified service personnel only. To reduce the risk of electric shock do not perform any servicing other than that contained in the operating instructions unless you are qualified to do so.

This lightning flash with arrowhead symbol within an equilateral trianQle is intended to alert the user to the presence of non-insulated “dangerous voltage within the product’s enclosure that may be of sufficient magnitude to constiture a risk of electric shock. Warning: To reduce the risk of electric shock, do not remove cover (or back) as there are no user-serviceable parts inside. Refer servicing to qualified personnel. The exclamation point within and equilateral triangle is intenaed to alert the user to the presenc_e of import nt operating and maintenance instructions in the literature accompany1nQ the appliance.

FEATURES

The Metro Suitcase Record Player has a full assortment of features at a popular, entry level price point! The 3-speed turntable will play 33 1/3, 45, and 78 RPM records. The Dual Bluetooth Feature allows you to stream music from another source through the Metro’s built-in stereo speakers or stream your vinyl albums to any external Bluetooth speaker. With a convenient carrying handle and latches, the Metro is ready to travel to where ever the Music goes. The 3.5mm Auxiliary& Headphone input all for even further playback options.

• 3-Speed record player will play 33 1/3, 45, 78 RPM records
• Bluetooth® In connectivity allows you to stream music from another source up to 33 feet away
• Bluetooth® Out Connectivity allows you to stream vinyl playback through any external Bluetooth Speaker
• Premium Carrying Handle and Metal Hardware allows for portability while giving the Metro a great look
• ncludes a 3.5mm Aux input & Headphone Jack for additional connectivity options
• Red Vinyl Finish with Silver Hardware & Black Carrying Handel
• Built in Stereo Speakers for playback convenience

Specifications

*Distance may vary depending on any objects or interference between devices.
SPECIFICATIONS AND ACCESSORIES ARE SUBJECT TO CHANGE WITHOUT NOTICE

PRODUCT OVERVIEW

• 1. Turntable Platter
• 2. Turutable Shaft
• 3. Tonearm
• 4. Tonearm Lever
• 5. Auto-stop Switch
• 6. Speed Switch
• 7. Hold Down Clip
• 8. 45 RPM Adaptor
• 9. Mode Indicator
• 10. Mode Knob
• 11. Power Indicator
• 12. Power/Volume Knob
• 13. Headphone Jack
• 14. LINE OUT Port
• 15. AUX IN Jack
• 16. DC Power Jack

SET UP & BASIC OPERATION

Power Connection

Ensure that the voltage of your home corresponds to the operating voltage of the unit. Your unit is ready to be connected to a SV DC adaptor.

Playing a Record

1. Place the record of your choice on the turntable. If required, use the 45 RPM adaptor on the record spindle.
2. Choose the desired playing speed using the speed selection switch (33.3, 45 or 78 RPM).
3. Turn on the Rotary Power Note that this also controls volume.
4. Release the tone arm lock.
5. Raise the arm with your hand lightly.
6. Place the stylus vertically over the first track of the record, the turntable will start turning automatically.
7. Put down the stylus slowly on to the record to play.
8. When a record comes to the end, the turntable will stop automatically if the auto-stop switch is in the ON position. If the switch is in the OFF position the turntable will keep revolving until the tone arm is returned to the tone arm rest.
9. Lift up the tone arm and put it on the rest when finished.
10. Replace the protective cap on the stylus and close the tone arm lock.
11. Turn off

Connect to External Audio System

You can listen to your new turntable using the built-in speakers but you may wish to connect it to your existing audio system. Connect the audio plugs to the Line input on your mixer or amplifier using an RCA cable (not supplied).

Connect a Bluetooth® Device to the Turntable

1. Switch the knob to Bluetooth® mode. A blue LED will begin flashing to indicate the turntable is in pairing mode.
2. Search for the turntable in the list of Bluetooth® devices named “VICTOR VSRP-800” and
3. A chime and a steady blue LED light will indicate you have paired with the turntable

Connect the Turntable to an External Bluetooth® Speaker

1. Turn on pairing mode on your Bluetooth® speaker.
2. Turn the Bluetooth® knob to the “BT Out” position on the The LED light flashes to indicate the device is searching for an available Bluetooth® speaker.
3. When the turntable connects to the Bluetooth® speaker, the LED light stays lit. After the speaker is paired successfully, turntable audio signal can be transmitted.
4. Adjust the volume on your unit and device to desired

MAINTENANCE

Maintaining the Turntable Needle (“Stylus”)

To extend the life of your stylus, dust the stylus occasionally with a very soft brush dipped in rubbing alcohol, brushing from the back to the front of the cartridge.

Maintaining Vinyl Records

To maximize sound quality and extend the life of your vinyl records, it is recommended you clean your records with an anti-static cloth after every use.

Transporting the Turntable

1. Place the protective cap on the
2. Put the rest clip into the pick-up arm.
3. Ensure the case is closed and the latch is

It’s suggested to replace the stylus after 400 hours of use. Please follow the steps below to change the stylus:

1. Lift the TONE ARM off the TONE ARM
2. At the front end of the tone arm, place the tip of your fingernail between the red stylus holder and the black cartridge housing as shown. Press down on the red stylus holder until it separ ates fromthe cartridge housing.
3. Completely remove the red stylus holder with worn stylus and discard
4. Place the new red stylus holder with stylus under the cartridge housing. First, press upward on the backside of the stylus holder, and then press up on the front edge of the stylus holder until it snaps into place on the cartridge housing.

FCC NOTICE

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including that may cause undesired operation.

NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment on and off, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is
• Consult the dealer or an experienced radio/TV technician for

WARNING: Any changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate this equipment.

The device must not be colocated or operating in conjunction with any other antenna or transmitter.

To maintain compliance with the FCC’s RF exposure guidelines, place the product at least 20cm from nearby persons.

IC STATEMENT

This device complies with RSS247 of Industry Canada.  This device complies with Industry Canada license-exempt RSS standard(s). Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device must accept any interference, including interference that may cause undesired operation of the device.

1. this device may not cause interference, and
2. this device must accept any interference, including interference that may cause undesired operation of the device.

The device must not be co-located or operating in conjunction with any other antenna or transmitter.

This device complies with IC radiation exposure limits set forth for an uncontrolled environment.

The device should be installed and operated with a minimum distance of 20cm between the radiator and your body.

CAUTION ON MODIFICATIONS

Any changes or modifications not expressly approved by the grantee of this device may void the authority granted by the FCC to operate this equipment. Electric and electronic equipment contains materials, components and substances that can be hazardous to your health and the environment, if the waste material (discarded electric and electronic equipment) is not handled correctly. Electric and electronic equipment is marked with the crossed out trash can symbol, seen below. This symbol signifies that electric and electronic equipment should not be disposed of with other household waste, but should be disposed of separately. All cities have established collection points, where electric and electronic equipment can either be submitted free of charge at recycling stations and other collection sites, or be collected from the households. Additional information is available at the technical department of your city.

SUPPORT

We do our best to offer high quality products to our customers. If you experience any issues or problems with your product, please contact customer support as many issues can be quickly resolved.

If you have problems with your device, please consult the instructions in this manual. Please also visit us on the web at www.naxa . com to get up to the minute news, alerts, and documentation for your device. For additional assistance, please contact Naxa Technical Support.

Naxa Technical Support

• 2320 East 491h St. Vernon, CA 90058
• 866-411-6292
• http://www.naxa . com/supportcenter

This product has been manufactured and sold under the responsibility of NAXA ELECTRONICS INC.

VICTOR and the DOG & GRAMOPHONE logo are trademarks used under license by NAXA ELECTRONICS INC. Further information at www.victor – brand.com.

All other products, services, companies, trademarks, trade or product names and logos referenced herein are the property of their respective owners.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>