KS-Power KS 2100iG S Inverter Generators User Manual

June 12, 2024
KS-Power

KS-Power KS 2100iG S Inverter Generators

KS-Power-KS-2100iG-S-Inverter-Generators-product

Product Information

This product is an inverter generator model KS 2100iG S or KS 3100iG S. It operates in gasoline mode and is designed to provide portable power. The generator has a multifunctional engine switch with different positions, such as START and RUN. It requires motor oil for gasoline engines, specifically SAE 10W-30 or SAE 10W-40. The generator should be operated with caution and following the provided instructions.

Product Usage Instructions

To properly use the inverter generator, follow the steps below:

  1. Read the operating manual carefully before starting.
  2. Fill the engine with motor oil suitable for gasoline engines, either SAE 10W-30 or SAE 10W-40.
  3. Check the oil level to ensure it is within the recommended range.
  4. Check the fuel level to ensure there is enough gasoline for operation.
  5. Close the gas valve on the cylinder to prevent any leaks.
  6. Open the vent on the fuel cap to the ON position.
  7. Turn the multifunctional engine switch to the START position (refer to Fig. 1).
  8. Pull the manual starter until you feel a slight resistance, then pull it sharply towards you. Slowly turn the manual starter by hand without releasing it abruptly.
  9. After the engine starts, turn the multifunctional engine switch to the RUN position.
  10. If the generator fails to start after several attempts, please contact our customer support at ks-power.de/en for assistance.

Please note that these instructions are specifically for models KS 2100iG S and KS 3100iG S in gasoline mode. Always refer to the product manual for accurate and model-specific instructions.

COMMISSIONING

  1. Please read the operating manual carefully before getting started.
  2. Fill the engine with motor oil for gasoline engines SAE 10W-30 or SAE 10W-40.
  3. Check oil level.
  4. Check fuel level.
  5. Close the gas valve on the cylinder.
  6. Open the vent on the fuel cap to the “ON”. Turn the Multifunctional engine switch to the “START” position (fig. 1).
  7. Pull the manual starter until a slight resistance is felt, then pull it toward you relatively sharply. Slowly turn the manual starter by hand, do not release it abruptly.
  8. Turn the Multifunctional engine switch to the “RUN” position.
  9. If the generator does not start after several attempts, please contact our customer support on the website: ks-power.de/en.

References

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals