EMOS ZS2712 LED Floodlight and PIR Sensor Instruction Manual
- June 4, 2024
- EMOS
Table of Contents
EMOS ZS2712 LED Floodlight and PIR Sensor
Dimensions
| Type | Input voltage | Max. power | Life span | Luminous flux | Dimensions |
|---|---|---|---|---|---|
| ZS2712 |
220–240 V AC
50 Hz
| 10 W|
50 000 h
| 1 100 lm| 95 × 160 × 54 mm
ZS2722| 20 W| 2 200 lm| 135 × 186 × 54 mm
ZS2732| 30 W| 3 300 lm| 160 × 223 × 55 mm
ZS2742| 50 W| 5 500 lm| 200 × 245 × 55 mm
This product contains a light source of energy efficiency class.
LED Floodlight + PIR SENSOR
LED Floodlight is designed for indoor and outdoor use to be mounted on firm ground. Ingress Protection IP65 – for outdoor use
PIR Sensor – Specification
- Time-delay min. 10 s ±3 s – max. 7 min ±2 min
- Detection angle 120°
- Ambient light 10 lux -> 2 000 lux (adjustable)
- Detection distance 2–10 m
PIR sensor setting:
The detection field is possible to be set by moving the motion sensor switch
up and down. To get the maximum detection angle, the sensor switch must point
to the side, i.e. across supervised premises.
Detection range
The distance at which the sensor responds to movement can be set using control
A. 
Maintenance instructions
Before maintenance, switch off the Floodlight and wait until it is cooled. Clean it with a soft moistened cloth. Never submerge the Floodlight in water or other liquids. During maintenance, observe general rules for occupational safety, and be very careful.
WARNING
- The LED Floodlight is designed entirely for firm mounting.
- Before connecting to the 220–240 V~ make sure that the connecting wire is not under voltage. This operation can be carried out only by an authorized person.
- Respect a minimum distance of 1 m between the appliance and the object or surface which you wish to lighten.
- If you place the Floodlight below the roof, keep the minimum 0.2 m distance measured from the upside of the Floodlight to the bottom of the roof.
Time-delay
You can set the time delay of the lamp by button C (see picture no. 4).
Adjustment of the ambient light (sensitivity) You can choose at what
luminosity will the sensor go on by a button B (see picture no. 4).
Mounting
Mount the Floodlight firmly onto a solid basis, for example, a wall (fig. 1,
2, 3).
Installation height: 2.3–3 m. Direct the Floodlight as shown on fig. 1
and 2.
- L – brown – live wire
- G – green &yellow – earth wire (ground)
- N – blue – neutral wire
Safety Instructions
- When using the Floodlight on a flammable surface, observe the above instructions.
- The Floodlight may only be connected to electrical mains with installation and protection that is in line with valid regulations and standards.
- Before interfering with the Floodlight or performing maintenance and repair, the light fitting must be disconnected from the mains. This must only be done by a knowledgeable/experienced person within the meaning of valid regulations on qualification for such activities.
- Do not use the LED Floodlight without the protection glass.
- The protection from dangerous contact voltage is ensured by „earthing“.
- If the external flexible cable or cord of this Floodlight is damaged, it shall be exclusively replaced by the manufacturer or his service agent or a similarly qualified person in order to avoid a hazard.
- The light source contained in this Floodlight shall only be replaced by the manufacturer or his service agent or a similarly qualified person.
- Caution , risk of electric shock.
- Type Y attachment.
EMOS spol. s r.o. declares that the LED Floodlight is in compliance with the essential requirements and other relevant provisions of the Directive. The device can be freely operated in the EU. The Declaration of Conformity can be found at http://www.emos.eu/download
Disposal
Do not dispose of domestic waste. Use special collection points for sorted waste. Contact local authorities for information about collection points. If the electronic devices would be disposed of in a landfill, dangerous substances may reach groundwater and subsequently the food chain, which it could affect human health.
Servis:
EMOS SI, d.o.o., Rimska cesta 92, 3311 Šempeter v Savinjski dolini, Slovenija
tel: +386 8 205 17 21
e-mail: reklamacije@emos-si.si
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>