LAPP SIGNAL R 3.0 A Circular Connectors with Solder Termination Instruction Manual
- June 12, 2024
- LAPP
Table of Contents
LAPP SIGNAL R 3.0 A Circular Connectors with Solder Termination
Product Information
- Product Name: Conductors
- Product Code: Dok.-Nr.: L99092886 vs00
- Panel Cut-out: M3 (4x)
- Gasket: Art.Nr. 50201203
- Safety Certification: ISO 1580 – M3 0,5 Nm
Product Usage Instructions
Assembly instruction
- Ensure that the product is not under load before performing any connection or disconnection.
- Locate the panel cut-out on the desired installation surface.
- Using four M3 screws, secure the conductors in place.
- Tighten the screws to a torque of 0.5 Nm using an appropriate tool.
- Install the gasket (Art.Nr. 50201203) to provide a secure seal.
Note: If the content of this bag will be split on two or more units, a copy of this instruction sheet must be placed in every packing unit.
Safety Information:
- CAUTION: Do not disconnect under load.
- ATTENTION: Ne pas utiliser pour couper le courant.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>