MINSUO 3 In 1 Magnetic 15W Wireless Fast Charger User Manual
- June 12, 2024
- MINSUO
Table of Contents
MINSUO 3 In 1 Magnetic 15W Wireless Fast Charger User Manual
Product Introduction
Thanks for purchasing our product penholder wireless charging lamp. It adopts
high-end quick charge IC ,with its luxury and compact design, it can be
compatible with any mobile phones with QI standard. it can perfectly
compatible with Sam sung, Apple fast charge wireless function, to save more
time effectively and improve your charging experience.
Standard Accessories
- 1* Wireless Charger
- 1* User Manual
- 1* USB Cable
Applicable Devices
- Devices with built-in quick charge/normal charge wireless receiver.
- Devices with outerface wireless charging receiver.
- Devices with wireless charging receiver in its protection case .
Note: All devices must be Qi standard.
Instructions
-
Connect the wireless charger to the AC power supply through the power adapter, turn on the wireless charger, the indicator light turns blue within seconds, and then the indicator light turns red and goes into the standby state.
-
Place your device vertically or horizontally in the center of the Wireless Changer until your device begins to charge.
-
The LED indicator light will become steady blue when charging mobile phone.
Specifications
Product name:Wireless charger
Input power : 18W max.
Input voltage: 5V/9V(QC3.0 and above)
Output power: 15W/10W/7.5W/5W/3W
Charging efficiency: 70%-80%
Dimension: 70x96x104mm
Attention
- Please keep the charger away from water or other liquid.
- If you need to lean the charger, please make sure it is power off.
- Using Environment tempeature remain 1-45℃ degree.
Warranty Card
During the product warranty period , if the fault is caused by the quality of
the product itself, the user is requested to contact the dealer with this
warranty card and purchase certificate to enjoy free repairs.
Free naubgannance us bit available in the following situations:
- There is no warranty card or the product repair label has been damaged.
- Damage caused by self-disassembly.
- Failure and man-made mechanical damage caused by water ingress or falling.
- Failure or danage casued by force majeure.
FCC STATEMENT
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
- This device may not cause harmful interference, and
- This device must accept any interference received, including interference that maycause undesired operation.
Warning: Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
Reorient or relocate the receiving antenna. Increase the separation between
the equipment and receiver. Connect the equipment into an outlet on a circuit
different from that to which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
FCC Radiation Exposure Statement:
This equipment complies with FCC radiation exposure limits set forth for an
uncontrolled environment. This equipment should be installed and operated with
minimum distance 20cm between the radiator & your body