Shenzhen Minsuo Industrial CS-365 Qi Wireless Charger Car Vent Mount User Manual
- June 6, 2024
- Shenzhen Minsuo Industrial
Table of Contents
Shenzhen Minsuo Industrial CS-365 Qi Wireless Charger Car Vent Mount
Thanks for purchasing our products.
(Includes: wireless charger, 100cm power cable, user manual.) Please read this
manual carefully before using the charger and keep it for consulting.
Specification
- Input/DC5V 2A
- Output 5W/7.5W/10W
- Product Standard Qi Standard
- Charging Distance ≤3-6mm
- Charging Efficiency ≤80%
- Product Material Environmental protection PC+ABS
5V/2A adapter is applicable to 5W standard wireless charging mode. 9V/1.67A adapter is applicable to iPhone 7.5W fast wireless charging mode. 9V1.67A adapter is applicable to Samsung 10W fast wireless charging mode. Fast wireless charging requires QC2.0/3.0 adapter.
Indicator light Status and Protection Function
Standby: Indicator light turns blue and flashes 3 times ,then turns off.
Charging: Indicator light keeps blue.It will turn off when the phone is fully
charged. FOD function will be enabled automatically when metal/magnet objects
are put onto
the charging pad. Over-voltage protection, over-current protection, over-
temperature protection and short circuit protection are available. The
indicator will turn red and flash if the wireless charger is not working well
.
Attention
- Please do not vigorously extrude or collide.
- Please do not dismantle or put it into fire or water when the product is powered on, to avoid short circuit or leakage.
- Please do not use it in severely high temperature, high humidity or corrosive environment, to avoid damage to the circuit leakage.
- Please do not put the magnetic strip or chip card (Such as ID card, bankcard etc .) on the charging pad to avoid failure of card.
- Do not put any metal materials like key,ring,metallic phone case etc. on the back of phone device in the processing of charging
Trouble shooting
- Check if the power outlet or adapter are working.
- Check the adapter (must be 5V/2A or QC2.0/QC3.0).
- Check the charging cable.
- Unplug and plug the charging cable again .
- Check if the phone is QI wireless charging standard compatible.
- Remove the phone case and try again.
Note: This product is applicable to all Qi standard wireless charging phones.Other phones need an external receiver for wireless charging function.
FCC STATEMENT
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
- This device may not cause harmful interference, and
- This device must accept any interference received, including interference that may cause undesired operation.
Warning : Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to
- Consult the dealer or an experienced radio/TV technician for help.
RF warning statement:
The device has been evaluated to meet general RF exposure requirement. The
device can be used in portable exposure condition without restriction.