Nien Made RC-S01 Remote Control User Manual
- June 12, 2024
- Nien Made
Table of Contents
Nien Made RC-S01 Remote Control
Remote Control
- Model #RC-S01
Product Specification
- Model: RC-S01
- Dimensions: Φ47*15mm
- Weight (including battery): 21g ± 5g
- Battery / Voltage: CR2032 3V (Lithium coin battery)
- Radio Frequency: 2.4GHz
- Operation Temperature: 0°C – 50°C / 32°F – 122°F
Button Overview
- A. Open Button: Tap once; shade opens to its upper limit
- B. Lower Button: Press to move shade downward slightly
- C. Close Button: T ap once; shade closes to its lower limit
- D. Raise Button: Press to move the shade upward slightly
- E. Stop Button: Press to stop shade in any position
Battery Replacement
The Remote Control uses one coin battery CR2032 which is pre-installed.
CAUTION: When installing the battery be sure to keep safely out of reach
of small children, primarily those age 6 and under.
Assigning Shades to Group
IMPORTANT: Please assign only one shade type to 1-Group Remote for optimal operation.
-
Shade Button
-
Remote SET mode
-
3-1 Quickly press the shade button 3 times on the shade you want to assign. The green light will flash while in pairing mode.
-
Press the SET button on the back of the remote control for 3 seconds to activate setting mode (LED will flash green), and the shade will be assigned to remote automatically. The shade will jog once when successfully assigned.
Repeat above steps 3.1 – 3.2 on assigned shade to remove from the group. The shade will jog twice when successfully removed the assignment. -
Press the SET button on the back of the remote control for 3 seconds again to deactivate setting mode (LED will stop flashing).
NOTE : Setting mode will time out after 20 seconds of inactivity.
FCC/IC Information
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
CAUTION: Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>