WORKSTEAD Canopy Sconce Instruction Manual

: June 12, 2024
: Workstead

Table of Contents

General Notes
Final Assembly
Electrical Configuration
Read User Manual Online (PDF format)
Download This Manual (PDF format)

Canopy Sconce
Instruction Manual

General Notes

THIS LUMINAIRE IS UL LISTED. WHEN INSTALLING LUMINAIRE, CONFORM TO ALL APPLICABLE LOCAL ELECTRICAL CODES, ORDINANCES, AND THE NATIONAL ELECTRICAL CODE (NEC).
FOR YOUR SAFETY AND PROPER OPERATION OF LUMINAIRE, READ AND UNDERSTAND ALL INSTRUCTIONS COMPLETELY BEFORE COMMENCING INSTALLATION OF THIS LUMINAIRE.
CAREFULLY UNPACK THE LUMINAIRE AND INSPECT FOR DAMAGE.
THIS PRODUCT IS RATED FOR ONE 40W MAX, G16.5 BULB.
SAVE THESE INSTRUCTIONS FOR FUTURE REFERENCE.
CAUTION
THIS PRODUCT SHOULD BE INSTALLED ONLY BY A LICENSED ELECTRICIAN.
WARNING
THE ELECTRICITY MUST BE TURNED OFF AT THE MAIN FUSE BOX BEFORE INSTALLING THIS LUMINAIRE. TURNING POWER OFF USING THE LIGHT SWITCH MAY NOT BE SUFFICIENT TO PREVENT ELECTRICAL SHOCK.
USE UL LISTED WIRE NUTS FOR THE WIRING CONNECTIONS IN THIS LUMINAIRE. WRAP WIRE NUT CONNECTIONS WITH UL LISTED ELECTRICAL TAPE.

2| wire nuts|
---|---|---
2| 1 ½” 8# x 32 machine bolts|
2| ½” #8 X 32 set screws|
1| mounting plate|
1| Tala Sphere 1 bulb|

Final Assembly

WORKSTEAD Canopy Sconce - Final Assembly Step 1
Shut off the main electrical supply to the junction box from the fuse box/circuit breaker. Turning power off at the switch is not sufficient.
Step 2
Locate junction box in the wall. Attach the mounting plate to the junction box using the junction box screws.
Step 3
Using the wire nuts provided, make electrical connections by following the electrical configuration table below. Ensure that all electrical connections are wrapped with ul listed electrical tape.
Step 4
Tuck the wiring into the junction box. Thread one of the set screws into the upper hole in the canopy until flush with edge of canopy.
Step 5
Hook set screw onto upper return on backplate. Allow canopy to rest flush with the wall. Thread lower set screw in until flush with edge of canopy.
Shade Install
Slide shade over exposed brass stem at top of fixture. Adjustment by applying gentle pressure on either side of the shade may be necessary to achieve perpendicular alignment.