FOREVER KW-510 Kids Watch User Manual

FOREVER KW-510 Kids Watch

Product Parts

Thank you for buying Forever brand product. Before use, read this instruction manual and keep it for future reference. Do not open the device on your own – any repairs should be car­ried out by a serviceman. Only use original parts and accessories supplied by the manufactu­rer. The device must not be exposed to direct fire or other heat sources. We hope that Forever will meet your expectations.

Introduction

Before using the kids watch, carefully read the instruction manual to ensure correct operation. Kids watch is a small telecommunication device, used to locate its position and send data. Operation of the device is based on GSM/GPRS mobile network.
IMPORTANT: The device reqwres mstallat,on of a micro SIM card with active service, allowmg to
make and rece,ve calls, with no PIN lock It 1s recommended to deactivate vo1cema1I When sen­
dmg mformat10n regardmg locat10n, the watch will reqwre access to mobile Internet, therefore,
you should buy at least 1 GB package Use of the watch may be associated with fees for usmg the
network and calls, m accordance with the operator’s tariff.

Specification

• Display: 1,83″ 240×280 px
• Touch screen: yes
• Standby time: do 3 days
• Charging time: 2 hours
• Strap length: 240 mm
• Battery: 700 mAh
• Camera: yes
• Microphone and speaker: built-in
• SIM card slot nano SIM (with no PIN lock)
• Compatibility: Android 5.1 , iOS  10.0

Device description

1. Camera
2. Turn on/SOS button/return to the main screen
3. Speaker
4. SIM card slot
5. Charging connector

The set includes

• smartwatch
• charging cable
• user manual
• silicon case

Charging

It is recommended to use a charger of output parameters of5 V—1 A. Charger Is not included in the set. Full charging time of the watch is approximately 2 hours. Connect the connector of the included charging cable to the charging connector on the device. Make sure that the device and cable connectors are connected to each other, and then connect the USB cable to a power source.

Installing the SIM card

A lways make sure your watch is turned off before inserting or removing the SIM card. Never inse rt or remove the SIM card when the watch is turned on. Open the SIM card slot with the screwdr iver included in the set, and then place the SIM card in a pos ition such that the SIM card chip is facing the top of the watch screen, you will hear a click signaling correct installation. Then close the SIM card slot

First run

After insta lling the SIM card in the watch and charging the device, you can sta rt it by pressing
and holding the on button. After sta rting, the watch connects to the mobile network.

Device operation

We operate the device via a touch screen. By sliding your finger on the screen, you can switch between individual functions and you select a given function by pressing the screen.

1. Video chat- allows you to make video calls.
2. The phone book- gives you access to contacts defined using the application.
3. Camera – allows you to take pictures with your device’s camera.
4. Telephone – allows you to make a telephone call by manually entering the number.
5. Chat· allows you to receive and send messages between the application and the device.
6. QR code· allows you to display the registration QR code and application QR code.
7. Gallery- allows you to view photos taken with the devi ce.
8. Educati on – the tab contains a mathematical game.
9. Calculator- the tab contains a calculator.
10. Steps allows you to read the number of steps taken after activating the activity measurement function in the application.
11. Alarm clock- alarm clock settings. Set the desired time and frequency of repeat.
12. Settings – allow you to change the following: mobile network, Wifi, Bluetooth, volume, brightness, menu style, device language. You will also find the option for sleep, restart, shutdown and device information there.
13. Stopwatch – the ability to use the time measurement function.

Use of application

Download the H Forever Care” app for iOS or nForever KidsCareH for Android.

Account and watch registration

In the registration window, enter or scan the watch code (REG CODE) found on the bottom of the package and in the watch. Enter your email address, name and password. Then select the language of the application and the area of use of the watch.

Functions

Chat: Send a text or voice message to the watch by typing it on the keyboard or recording it using the phone’s microphone. You can also listen to the voice mails sent from the watch here.
Route: select the date and time slot to display the traveled route.
Map: Select the map icon to view the current location of the watch.
Safety zone: designate a safety zone, when the watch will found outside the selected zone, you will receive a notification from the app.
Reward: Select the number of rewards you want to send to your child. After approval, the information about the award will be sent to the watch.
Alarm clock: alarm clock settings. Set the desired time and frequency of repeat.
Find Watch: Select a feature to find your device if it’s near you. The watch will ring to inform you of its location.
Notifications: This is where you get and preview any notifications and alarms you receive from the watch.
Remote camera: take a photo using the watch camera and receive it on your phone. The captured image appears after a certain waiting time, depending on the signal strength of the cellular network.
My profile:

• Personal data: Your account settings
• Device list: Add, edit or remove a connected devices
• Change Password: Change the password for your account.

Settings

SOS numbers: when the watch user presses and holds the SOS button, the watch makes an automatic emergency call to three contacts defined on list.
Voice monitoring: enter the phone number to be called from the watch in order to listen to its surroundings. Pick up the call and check what’s happening nearby. The user of the watch has no notification that such a call has been made.
Do not disturb: Select the time during the day when the user of the watch will not receive phone calls.
Location mode: select normal mode – refreshing the watch’s location once every ten minutes, power saving- once every hour, tracking – once every minute.
SMS notifications: enter the number to which you want to receive SMS notifications about events such as: low battery level in the watch, triggering the SOS alarm using the watch button. Phone book: Define up to ten contacts that the watch user will have in the phone book. Time zone: set your time zone than the device shows the correct date and time on. Language: Choose language for your device from the available.
Settings switch: Enable or disable the watch function.
LBS Location: Enable or disable location using network operators antennas.
Turn off watch remotely: watch will be turned off.

FAQ

If the application does not accept commands and shows information that the watch is not on line. ( OFF-LINE)

1. Check if the SIM card is correctly installed in the watch, if the card supports 4G internet and that if an internet data package is available. If the coverage columns are still crossed out go to the next step.
2. Check if the GSM signal is correct – that the coverage columns are available/visible on the display. – – If they are crossed out, please turn the watch off and switch the watch on. If the coverage columns are still crossed out go to the next step.
3. Check if the data transfer arrows appear, if not, please set the APN (Acces Point Name – specific packet network). To do so please send an sms to the watch number with the content pw,123456,apn,YYY…XXXXX#

• the character XXXXX indicates digits assigned to a specific operator

  • 26003 – ORANGE
  • 26001 – PLUS
  • 26006-PLAY
  • 26002 – T-MOBILE

other digits of the codes are available on www.mcc-mnc.com

• the YVY sign means the name of the APN from a particular operator internetipv6. or internet – ORANGE

  • plus – PLUS
  • INTERNET – PLAY
  • internet – T-MOBILE

other APN names are available on operators’ websites or at their info lines An example of correct sms for Play network has the form pw,123456,apn, INTERNET, 26006# After sending the message you should wait several minutes until KidsWatch downloads the settings from the network. The data transfer arrows should appear. If the coverage columns are still crossed out go to the next step.
Check the watch parameters according to the instructions below and compare the data received in the SMS with the data of the watch (specially watch paper lebel with IMEl number). Send an sms from your phone pw,123456,ts# to the number of the SIM card inserted in the watch. In reply the watch will send you the watch parameters. Example:

• ver:G36WS_YDE_V1.1_2019.12.19_09.45.40;
• ID: 1234567890;
• imei:123456789012345;
• ip_url:52.28.132.157;
• port:8001;
• upload:6005;
• bat level:96;
• language:1;
• zone:8.00;
• ec:O;
• NET:OK(73);

If the ID/IMEl/REG CODE number differs from the number on the badge pinned to the watch or the bottom of the packaging, a new IMEl number must be set. To do this, send a text message from your phone to the card number of the watch: pw,123456,imei, xxxxxxxxxxxxx# where X are the digits of the badge – the watch will reply with the correct IMEI number, for example:pw,123456,imei,359614514986574#
If the IP_URL and PORT is different than in the example above, send an SMS from your phone to the SIM card number installed in the watch with the text ow. 123456,p. 52.28.132.157,8001# the watch will send back an SMS in reply with the contents (surl,52.28132.157,port,8001#] ok! The line from GPRS/NET should contain „OK.” If it is „NO” the watch is not connected to the network. Please follow 9.1 The value in brackets shows the signal strength.

NOTE: please pay attention to punctuation marks and spaces when writing text messa- ges. This is very important as failure to use the characters correctly will result in com- mands being misinterpreted by the watch and will go unanswered. You cannot call the watch. The signal is busy or the subscriber does not answer

Reason: The watch does not recognise the incoming number or ,,do not disturb” mode is set in the app.

Solution:

• Check that the number you are calling from is not restricted.
• Check that contact numbers are set in the app.

The watch only receives calls from numbers previously set in the app’s contacts.

The watch does not show the current time and date
Reason: The watch has not connected to the app server to update the time. Solution:

• If the watch shows a few hours back, check and select the correct time zone via the app.

• If the above does not help, send from your phone (to the SIM card number installed in the watch)
  SMS: pw,123456,ntpservers,121.40.88.40,8089#
  In response, the watch should send an SMS with a similar content of nOK”. After this action, restart the watch.

• In addition, you can send a configuration SMS to the SIM number of the watch with the follo­wing contents: pw,123456,time,hour.minute.second,date,year.month.day# – for example, sta­ting the current time and date: pw,123456,time,09.50.00,date,2023.06.01#

Rules for safe use

-SECURITY-
Please read these tips carefully. Failure to follow these instructions may be dangerous or illegal.

• DO NOT RISK –
  Do not switch the device on in places where the use of electronic devices is forbidden, or when it may cause interference or other hazards. Comply with all kinds of prohibitions, regulations and warnings provided by the personnel of the place where you want to use the device.

• PROFESSIONAL SERVICE –
  Only qualified service of the manufacturer or an authorized service center may repair this product. Repairing the device by an unqualified service center or by an unauthorized service point may damage the device and void the warranty.

• MODIFICATIONS –
  The manufacturer is not responsible for damage caused by unauthorized modifications.

• MOBILE AND MENTAL DISABILITIES AND CHILDREN –
  The device should not be operated by people (including children) with limited mobility or men­tal , as well as by people who have no experience in the use of electronic equipment. They may use it only under the supervision of persons responsible for their safety after reading and understand the instructions on how to use the device safely.

• SURROUNDINGSE-
  The device should not work in dusty conditions. Connect the device in such a way that it cannot be a age and does not pose a threat to people and animals. Do not expose the device to sunlight and do not use it, or leave it in the immediate vicinity of devices that emit a lot of heat (heaters, radiators, etc.). Plastic elements may deform, which may affect the operation of the d vice or lead to its complete damage.
  Keep the device and its packaging out of the reach of children. Cables and plastic bags can become wrapped around a child’s neck and cause suffocation. The device is not a toy.

• WATER AND OTHER LIQUIDS –
  Do not expose the device to water or other liquids. Avoid working in an environment with high humidity – steamy kitchens, bathrooms, etc. Water particles can cause moisture to appear in the device, which adversely affects the electronics and can damage the equipment.

• BATTERIES
  Avoid exposing the battery to very cold or very hot temperatures. Extreme temperatures can ffect the capacity and lifetime of the battery. Avoid exposing the battery to liquids or metal a its intended purpose. Do not destroy, damage or throw the battery into fire – it can be danger rousand cause a fire. Used or damaged batte ry should be placed in a special container. Overcharging the battery may damage it. Therefore, do not charge the battery longer than necessary to fully charge it.

Proper disposal of used equipment

This device is marked with a crossed-out garbage container symbol, in accordance with the European Directive 2012/19/EU on Waste Electrical and Electronic Equipment (WEEE). Products marked with this symbol should not be disposed of or discarded with other household waste at the end of their service life. The user is obliged to dispose of waste electrical and electronic equipment by delivering it to a designated point, where such hazardous waste is recycled. The collection of this type of waste in separate locations and the proper recovery process contri- butes to the conservation of natural resources. Proper recycling of waste electrical and elec- tronic equipment is beneficial to human health and the environment. For information on where and how to dispose of used electronic equipment in an environmentally safe manner, the user should contact the relevant local authority, the collection point or the point of sale where the equipment was purchased.

Proper disposal of used battery
In accordance with EU Directive 2006/66/C, as amended by Directive 2013/56/ EU on the disposal of batteries, this product is marked with a crossed-out garba- ge container symbol. This symbol means that the batteries used in this product should not be disposed of with ordinary household waste, but handled in accor- dance with the directive and local regulations. Do not dispose of batteries with unsorted municipal waste. Battery users must use available collection network for these items, that allows for their return, recycling and disposal. Within the EU, the collection and recycling of batteries is governed by separate procedures. To learn more about existing battery recycling procedures in your area, contact your city hall, waste management agency or landfill.

Declaration of Conformity with European Union Directives
TelforceOne Sp. z o.. hereby declares that the device Kids Watch KW-510 Lo- ration of Conformity is available at the following web address: https://www.ma- nual.forever.eu/KW510

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>