Anmytek C0003 Round Wooden Chandelier Instruction Manual
- June 12, 2024
- Anmytek
Table of Contents
Anmytek C0003 Round Wooden Chandelier
Anmytek Product Information
- Product Name: Anmytek
- Contact Email: service@anmytek.com
- Item Number: C0003
Product Usage Instructions
WARNING (To reduce the risk of fire, electric shock, or injury to persons):
-
We suggest installation by a licensed electrician.
Please read the instruction carefully and save it as you may need it at later time. -
Before you start, NEVER attempt any work without shutting off the electricity until the work is done. A). Go to the main fuse, or circuit breaker, box in your home. Place the main power switch in the “OFF” position. B). Place the wall switch in the “OFF” position.
-
Mounting surface should be clean, dry, flat, strong enough and 1/4” larger than the canopy on all side. Any gaps between the mounting surface and canopy exceeding 3/16” should be corrected as required.
-
Make sure that the ceiling or wall can stand the weight of the lamp before fixture.
-
Make sure the voltage you are using is 120V. The maximum wattage is 60W per bulb.
-
Keep the lamp away from acidic and basic objects in case of damaging the surface of the lamp.
-
When replacing bulb, you should turn off or unplug the lamp and you must wait until it is cool as bulbs get hot quickly.
-
The safety instructions appearing in this manual are not meant to cover all possible conditions that may occur. It must be understood that common sense, caution and care must be used with any electrical products.
Image for the finished product:
Installation Procedures:
- Open the package and take out all the parts or accessories, then place them on a clean flat place.
- Fix the middle tube to the middle box and wire box.
- Fix the tube 5 to the middle box and lamp body.
- Fix the glass globe 6 to the lamp holder by ring 7.
- Fix the part 1 to the ceiling by using the screw 2.
- Connect the wire from lamp to the Ceiling, wiring instructions
- Fix the canopy 3 to the ceiling by using the screw cap 4.
- Install bulbs 8. (Bulb not included)
- Check everything installed correctly, then you can turn on the light.
