TiramisuBest JT-3213 Portable Basketball Hoop User Manual

TiramisuBest JT-3213 Portable Basketball Hoop User Manual

GET TO KNOW THE BASIC PARTS

BACKBOARD

BASE

SUPPORT POLE

SPARF PARTS

• M8 x 110mm 10
  

• M8 x 90mm 11

• M8 x 80mm 12
  

• M8 x 40mm 13

• M8 x 20mm 14

• M8 x 16mm 15

TOOLS NEEDED

Please prepare the following tools before assembly:
Note: All screws are designed to prevent loosening and must be installed and tightened with a wrench.

• wrench

• wrench

• water pipe

INSTALLATION STEPS

BASE

BACKBOARD

COOL INDUCTIVE LED FOR BASEKETBALL RING

1. Brief Introduction:
   This led product is the auxiliary device of basketball frame. It presents different cool lighting effects according to different scoring methods, adding more interesting and fun sports atmosphere  for pitchers.

2. Product function:
   Normal state: In the non-inductive state, there are two states: low brightness white light and no light, controlled by plug-in power supply. Plug in the power supply, and the light is always in ice blue color. If the light is off after 35, it will be off when it is not normally sensed; Plug in the power supply, and the light is always bright ice blue. If the light is low bright white after 3s, it will be low bright white when it is not normally sensed. Box goal: basketball vibration ball frame into the net, 12 cool lighting effects in turn, each mode lights last 3s; Through the heart goal: always in ice blue color for 3s.
   Note: the effective induction time of two goals should not be less than 2s.

3. Product Parameter:
   Work voltage: DC4.5V (3PCS AA dry batteries)
   Work current: The maximum current is 500mA when the induction lamp is on for 3S.

4. Product installment:
   Product general assembly diagram./
   

5. surround the LED light belt around the basketball metal frame with the light bead facing out, Try to keep the light strip on the lower edge of the basketball hoop to reduce the probability of basketball impact , then lock it with the tie belt at a proper position, and cut off the redundant tie belt.
   

6. Two side 3M adhesive tape with one side pasted with induction control box.

7. Place the other side flat on the bottom of the basketball hoop and the backboard, in the middle of the position, and try to keep the sensor and the hoop as far away as possible to prevent misjudgment caused by brushing the frame.
   

8. Install 3 AA batteries into the battery box, and stick the back of the battery box with strong 3M tape
   

9. Sick the battery box to the basketball frame post with 3M tape.
   

10. Press the switch, the LED can work normally.

Tips: If you do not use this product, please turn off the battery box switch fo prevent self-power consumption.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>