TiramisuBest JT-3212 Portable Basketball Hoop User Manual
- June 12, 2024
- TIRAMISUBEST
Table of Contents
TiramisuBest JT-3212 Portable Basketball Hoop
GET TO KNOW THE BASIC PARTS BACKROAD
BASE
SUPPORT POLE
GET TO KNOW THE BASIC PARTS AND SPARE PARTS
TOOLS NEEDED
Please prepare the following tools before assembly:
Note: All screws are designed to prevent loosening and must be installed
and tightened with a wrench.
INSTALLATION STEPS BASE
BACKBOARD
FINAL INSTALLATION
COOL INDUCTIVE LED FOR BASKETBALL RING
Brief Introduction:
This led product is the auxiliary device of the basketball frame. It presents
different cool lighting effects according to different scoring methods, adding
a more interesting and fun sports atmosphere for pitchers.
Product function
Normal state: In the non-inductive state, there are two states: low brightness
white light and no light, controlled by the plug-in power supply. Plug in the
power supply, and the light is always in ice-blue color. If the light is off
after 3S, it will be off when it is not normally sensed; Plug in the power
supply, and the light is always bright ice blue. If the light is low bright
white after 3S, it will be low bright white when it is not normally sensed.
Box goal: basketball vibration ball frame into the net, 12 cool lighting
effects in turn, each mode lights last 3S; Through the heart goal: always in
ice blue color for 3S.
Note: the effective induction time of two goals should not be less than
2S.
Product Parameter
Work voltage: DC4.5V (3PCS A dry batteries)
Work current: The maximum current is 500mA when the induction lamp is on for
3S.
Product installment
Product general assembly diagram
- surround the LED light belt around the basketball metal frame with the light bead facing out, Try to keep the light strip on the lower edge of the basketball hoop to reduce the probability of basketball impact, then lock it with the tie held at a prisoner position and cut off the redundant tie belt
- Two sides of 3M adhesive tape with one side pasted with induction control box.
- Place the other side flat on the bottom of the basketball hoop and the backboard, in the middle of the position, and try to keep the sensor and the hoop as far away as possible to prevent misjudgment caused by brushing the frame.
- Install 3 AA batteries into the battery box, and stick the back of the battery box with strong 3M tape
- Stick the battery box to the basketball frame post with 3M tape.
- Press the switch, and the LED can work normally.
Tips : If you do not use this product, please turn off the battery box switch to prevent self-power consumption
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>