SAFETY VISION SV-CB126-AHD Ultrasonic Sensor System User Manual
- June 12, 2024
- SAFETY VISION
Table of Contents
SAFETY VISION SV-CB126-AHD Ultrasonic Sensor System User Manual
This device complies with part 18 of the FCC Rules.
This equipment has been tested and found to comply with Part 18 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
CAUTION : Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the product.
NOTE : This equipment generates , uses and can radiate radio frequency energy and , if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation . If this equipment does cause harmful interference to radio or television reception , which can be determined by turning the equipment off and on , the user is encouraged to try to correct the interference by one or more of the following measures: Reorient or relocate the receiving antenna . Increase the separation between the equipment and receiver. Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. Consult the dealer or an experienced radio/ TV technician for help.”
FEATURE
The intelligent ultrasonic sensor is designed for commercial vehicle such as vans, motorhomes and heavy goods vehicle. The system provides active warning with visual and audible beeping alerts, alert you of detecting object as far as 2.4M. There are 4° / 8° / 12° sleeves can be chosen, allow lower mounting while still providing a high quality performance.
SYSTEM COMPONENTS
Confirm the version of sensor which you need, drill-hole or suspended version. There are two different sensor components as above.
Optional Components:
ALARM1 BUZZER1
BUZZER EXTENSION CABLE1
SLEEVE ( 4° / 8° / 12°, 4 EACH ) OR SUSPENDED BRACKET
(INCLUDING RUBBER PAD)4
Remark: After checking that you have received all the above items, connect the system with peripheral equipment following the instruction below!
Connection of the Whole System
Functions
Switch Function
switch1: UP—L/CL/CR/R sensor detect range 2.4M.
switch1: DOWN—L/R sensor detect range 0.9M. CL/CR sensor detect range 2.4M.
switch2: UP — normal OSD display.
switch2: DOWN — flipped OSD display (camera image is not affected)
Installation
DISCLAIMER
In below case, a object might not be detected.
- A small object, which is under your bumper or too close to the vehicle, may not be detected.
- When reversing down a steep slope or driveway, gravel and/or the road surface may cause momentary detection signal.
- Reversing on loose gravel, rough surface, and pot holes may produce intermittent detection.
- Reversing at an angle towards a partial wall or other large flat surface may refract ultrasonic signals.
- If reversing towards a 90° angle such as a corner of a wall or a pillar.
- Due to natural projection angle of the sensors, a nature “no coverage” area is common with the system at the outer corners of the vehicle, this may occur at about 0-10 “from the bumper’s outer corners.
CAUTION :
This system only being used as an assistant tool for driving and parking
vehicles , User should make judgments on his own discretion. We and our
products take NO responsibility for traffic accidents caused by driving and
parking.
SPECIFICATIONS
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>