WAV-LINK TOP-R1200 WiFi Range Extender 1200Mbps Dual Band Wifi Repeater User Guide

October 27, 2023
WAV-LINK

WAV-LINK TOP-R1200 WiFi Range Extender 1200Mbps Dual Band Wifi Repeater User Guide

Product Overview

ft -REA
Power lamp When the product is plugged into the power socket, it !ights up

after power on, .
indicating that the product is
in ncIrmal crate
WPS signal
lamp| When this light is on, it indicates that WPS fast encryption is enabled
WIFI signal
lamp| When the product is connected tc the wireless network, or a wireless device is connected to the repeater, this light is on, indicating that the connection is normal
LAN signal
lamp| When the cable network access or network cable connected to the
LAN interface| AP mode can be used as
wired network access, relay mode can be used as wired network output.
Reset Button| Press and hold the reset key for 10 seconds to restore the factory setting
WPS Button| Fast encryption button to protect data transmission security

As a WiFi signal extender, repeater can expand your WiFi signal without using any cables, reducing the trouble of wiring, but it can’t optimize the speed of WiFi.

Repeater must be able to receive WiFi signal within the scope of normal work, not out of WiFi range.

Power on

Connect the repeater to the power supply and wait for the WiFi signal indicator to light up.

Configuration steps

Click repeater XXX, the hotspot of connecting repeaters. If you don’t jump to the login authentica-tion page as shown in the figure below, please use your mobile browser to enter the IP address of the webpage: 192.168.11.1 to jump to the login authenti-cation page.

Extender WiFi Settings

Extend the Signal of your home WiFi network,through the wall.

User Login

Click next in the red box below to enter the repeater configuration mode.

Extender WiFi Settings
Extend the signal of your home Win network, through the wall

Repeater Mode Settings

Select the WiFi to enhance the signal and click.

Extender WiFi Settings
Extend the signal of your home WiFi network, through the wall

WiFi Signal

Extender WiFi Settings
Extend the signal of your home Wifi network, through the wall.

Click next to enter the next page and click Finish configuration. So far, the repeater configuration is complete, you can now start to enjoy the network!

The picture above shows the operation

ANT

The antenna is Ipex antenna, and is detachable antenna. the antenna is 2.4G:1.08dBi,5G:1.13dBi, This antenna is permanently paired with a product to sell. ( Only antennas of the same type and with equal or less gains as shown below may be used with the The Wireless Repeater. Other types of antennas and/or higher gain antennas may require additional uthorization for operation)

Ipex antenna

FCC Statement

This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

Any Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.
This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

  • Reorient or relocate the receiving antenna.
  • Increase the separation between the equipment and receiver.
  • Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
  • Consult the dealer or an experienced radio/TV technician for help.

This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with minimum distance 20cm between the radiator & your body.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals