PHILIPS TT150 TC TT Downlight Instruction Manual
- June 12, 2024
- Philips
Table of Contents
PHILIPS TT150 TC TT Downlight
Product Information:
The TC TT Downlight is a lighting fixture available in different models, including TT150, TT155, TT160, TT165, TT170, TT175, TT180, TT185, TT190, TT195, TT200, TT205, TT210, TT215, TT220, TT225, TT230, TT235, TT240, TT245, TT250, TT255, TT260, TT265, TT270, TT275, and TT280. It is compatible with optional accessories such as the Connector GST18i3 (3 pole, male, mains cable), Connector BST14i2 (2 pole, male), and Polycarbonate cover. The luminaire is designed for 220V-240V power supply with a frequency of 50Hz- 60Hz. It has been approved as an IP54 enclosure and comes with dimensions specified in millimeters.
Product Usage Instructions
- Ensure that the power supply is within the specified range of 220V-240V and the frequency is either 50Hz or 60Hz.
- Select the appropriate model of the TC TT Downlight based on your requirements.
- If desired, attach optional accessories such as the Connector GST18i3 or Connector BST14i2 according to your installation needs.
- If using a polycarbonate cover, make sure to select the appropriate version that supports IK06 IP54 protection.
- Ensure that the luminaire is installed in a suitable cutout size. For C = 150 or 200, the cutout size should be at least 225mm.
- Do not cover the luminaire with thermal insulation matting or similar materials.
- If through-wiring is required, follow the provided instructions for connecting the mains cable and other components.
- If using a DALI or Touchdim system LED driver, connect the appropriate wires according to the provided wiring diagram.
- Refer to the electrical characteristics and inrush current information to determine the compatibility with your electrical system.
- For maintenance or servicing, disconnect the power supply before proceeding.
TC TT Downlight
INSTRUCTION
The housing of the luminaire has been reviewed and approved as an IP54
enclosure. 
Disconnect before servicing
Luminaire has basic insulation between Low Voltage supply and control conductors.
The control gear and/or the external flexible cable contained in this luminaire shall only be replaced by the manufacturer or his service agent or a similar qualified person. The light source contained in this luminaire is not replaceable, in case of damage replace the luminaire. Storage, installation, use, operation and maintenance of the products needs to be performed exactly according the instructions in this manual and/or other instructions as may be provided by us to guarantee safe use of the product over its entire lifetime. Failure to adhere to these instructions will invalidate your entitlement to warranty. Bolts with indication of torque strength on the drawing need to be tightened using a calibrated torque wrench. Pre-assembled bolts need to be retightened again to the required torque specification to assure maximum strength over lifetime.
This product contains a light source of energy efficiency class: see table or label.