METCAL UFC-6CH5106S UFC Ultra-Fine Cartridges User Manual
- June 12, 2024
- METCAL
Table of Contents
UFC Ultra-Fine Cartridges for work in tight spaces are compatible with
CV-5200, CV-500
Systems and Ultra-Fine Solder Hand piece CV-H2-UF.
UFC-6CH5106S UFC Ultra-Fine Cartridges
| Temperature | CV-Serie | Application |
|---|---|---|
| 675 °F/357 °C | UFC-6 | Temperature Sensitive |
| 775 °F/413 °C | UFC-7 | Most Standard |
Please note the above temperatures are the maximum temperatures of the heater. The idle temperature is dependent on the geometry of the cartridge (up to 15˚C lower.)
Ultra-Fine Chisel Cartridge
| UFC-6CH5106S
UFC-7CH5106S| (W x L) 0.6 x 5.1 mm
| UFC-6CH9006S
UFC-7CH9006S| Long reach,
(W x L) 0.6 x 9 mm
| UFC-6CH5108S
UFC-7CH5108S| (W x L) 0. 8 x 5.1 mm
| UFC-6CH9008S
UFC-7CH9008S| Long reach,
(W x L) 0.8 x 9 mm
| UFC-6CH5112S
UFC-7CH5112S| (W x L) 1.2 x 5.1 mm
| UFC-6CN5101S
UFC-7CN5101S| (ø x L) 0.13 x 5.1 mm
| UFC-6CN5102S
UFC-7CN5102S| (ø x L) 0.2 x 5.1 mm
| UFC-6CN5502R
UFC-7CN5502R
| Bent 30°,
for work under a microscope,
(ø x L) 0.2 x 5.6 mm
| UFC-6CN5504S
UFC-7CN5504S
| For work in tight spaces,
(ø x L) 0.4 x 5.1 mm
| UFC-6CN5504R
UFC-7CN5504R
| Bent 30°,
for work under a microscope,
(ø x L) 0.4 x 5.6 mm
| UFC-6CN8004S
UFC-7CN8004S
| Long reach,
(ø x L) 0.4 x 8.0 mm
Ultra-Fine Rework Hoof-Cartridges – For Drag Soldering SOIC/QFP’s
| UFC-6HF5108S
UFC-7HF5108S
| Micro Hoof,
(Bevel/L) 45° x 1.13 mm,
(ø x L) 0.8 x 5.1 mm
| UFC-6HF5112S
UFC-7HF5112S
| Micro Hoof,
(Bevel/L) 45° x 1.71 mm,
(ø x L) 1.21 x 5.1 mm
www.okinternational.com
www.metcal.com
References
- Metcal - Advanced Manufacturing Solutions
- Metcal - Advanced Manufacturing Solutions
- OK International - Global Advanced Manufacturing Equipment
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>