UNILITE HT-900R High Power Industrial Headtorch User Guide
- June 12, 2024
- Unilite
Table of Contents
UNILITE HT-900R High Power Industrial Headtorch
Product Overview
Product Information: HT-900R
The HT-900R is a headtorch designed for various lighting needs. It features a cool white Cree LED that provides high, mid, and low brightness settings. The headtorch has a maximum output of 900 lumens on high mode, 340 lumens on mid mode, and 30 lumens on low mode. The product comes with a rechargeable 3.7v 2600mAh Li-ion battery, weighing approximately 185g. The dimensions of the headtorch are W44 x H39 x D46mm, and the battery pack dimensions are W86 x H36 x D37 mm.
Product Usage Instructions:
Operation
To operate the headtorch, use the switch sequence HIGH > MID > LOW > OFF.
Press the switch button to cycle through the different brightness modes. The
headtorch can be turned off by pressing the switch button until it is in the
OFF position.
Battery
The headtorch comes with a rechargeable 3.7v 2600mAh Li-ion battery. To charge
the battery, follow these steps:
- Only use a 5V USB-C cable (max 1A).
- Plug the USB-C end of the cable into the charge port on the bottom of the battery pack.
- Plug the USB-A end of the cable into a USB charging port (do not exceed the stated Max charging input).
The charging indicator will flash green when charging and turn solid green when fully charged. The battery level indicator on the headtorch will light up for 10 seconds when the headtorch is turned on.
Important Information
- Do not look directly at the LEDs as they can be bright and may cause discomfort.
- Take care when using USB plug adaptors and check for any damage before use.
- Do not touch the LEDs when they are switched on as they can become warm/hot.
- Avoid contact with damaged lithium battery fluid as it can cause skin irritation and/or burns. Rinse thoroughly with water if skin contact occurs.
- Children under 12 years of age should only use the product under adult supervision.
- Do not open, disassemble, or modify the product as it can be dangerous and void the warranty.
- Avoid letting lenses come into contact with hard/sharp objects to prevent damage or scratches that can affect light output.
- Clean the product with a slightly moist, clean, lint-free cloth and a mild detergent if required. Do not use cleaners that contain abrasives or solvents.
- Do not expose the product to excessive moisture/water as it may void the warranty.
- Dispose of the product properly at an authorized electrical appliance disposal center or local waste disposal unit. Reuse or recycle packaging responsibly where possible.
- Keep these instructions for future reference or for subsequent possessors of the product.
- Do not look directly at LEDs.
- Do not operate in direct sunlight or extreme temperature conditions (below -20°C or above 60°C).
- LEDs can become warm/hot when switched on; do not touch and never place face down on any surface – risk of fire!
- Do not use the device if there is any visible damage.
- Take care when using USB plug adaptors, check for any damage. Check the charging output on the plug and DO NOT exceed the stated Max charging input or damage may occur to the battery and may void the warranty.
- The rechargeable battery will reach full performance after a few complete charging and discharging cycles.
- To keep the rechargeable battery in optimum condition, it should be recharged every 3- 6 months, especially if it is not being used for a long period of time. Always fully charge batteries before storage.
- Always protect lithium batteries from heat, intense sunlight, fire, water and moisture – danger of explosion!
- If a battery is damaged, fluids can leak out. AVOID contact as this can lead to skin irritation and/or burns. If skin contact occurs, rinse thoroughly with water. If irritation persists, seek medical advice. Seek immediate medical assistance if lithium battery fluid comes into contact with the eyes.
- Children under 12 years of age should only use the product under adult supervision.
- Do not open, disassemble or attempt to modify the product; this will void the warranty and can be dangerous. Improper use or modification is not covered under the warranty. Take care not to let lenses come into contact with hard/sharp objects, damage/scratches to lenses will affect light output.
- Do not use the product in the immediate vicinity of flammable materials or gases.
- Before cleaning the product, disconnect the charge cable. Clean with a dry or slightly moist, clean, lint-free cloth and a mild detergent if required. Do not use cleaners that contain abrasives or solvents.
- This product is water resistant to IPX5 – DO NOT SUBMERGE. If the product has been subjected to excessive moisture/water the warranty may be void.
- This product has a 1 year standard warranty (or extended to 2 years once registered online at WWW.UNILITE.CO.UK/WARRANTY) against manufacturing faults and defects. It does not cover normal wear and tear, modifications, accidental damage or poor maintenance. Unilite warranties do not cover disposable battery leaks or the use of incorrect chargers and cables that can damage rechargeable batteries.
- Do not dispose of this device in normal household waste. It must be disposed of via an authorised electrical appliance disposal centre or at your local waste disposal unit.
- Please re-use or recycle packaging responsibly where possible.
- Keep these instructions for future reference or for subsequent possessors.
Memory Function:
The headtorch has a memory function that turns it off if left ON in any mode
for 5 seconds or more. The next press will turn the headtorch OFF. The next
press ON will return to the last mode used before turning it off.
FEATURES
- High power 900 lumen white Cree LED, 6500k
- Wide angle light spread with bright central spot
- Super tough construction
- Memory Switch – remembers last mode used
- Fully adjustable non-slip silicone lined headband
- 4 x Helmet clips included
- 72˚ rotational head
- IP65 dust & water resistant
- IK07 shock proof – 2m drop resistant
- Rechargeable 3.7v 2600mAh Li-ion battery
- Useful battery level and charging indicator
- Quick 4.5 hour USB-C charge time
- 1m USB-C charging cable included
Specifications
- BATTERY – 3.7v 2600mAh Li-ion Rechargeable Battery
- WEIGHT – 185g
- DIMENSIONS – Headtorch: W44 x H39 x D46mm
- Battery Pack : W86 x H36 x D37 mm
ANSI FL1 Standard
OPERATION
Switch Sequence: HIGH > MID > LOW > OFF
MEMORY FUNCTION:- If left ON in any mode for 5 seconds or more, the next press
will turn OFF. Next press ON will return to last mode used.
CHARGING
- Only use a 5V USB-C cable (max 1A).
- Plug the USB-C end of the cable into the charge port on the bottom of the battery pack.
- Plug the USB-A end of the cable into a USB charging port (do not exceed 5V-1A charging input or damage may occur).
- Green flash indicates charging, Solid Green indicates fully charged.
- Charge Time: 4½ hours
- Make sure the charge port cover is secured back in place.
Warranty void if not used with the specified cable & max charge input
CHARGING INDICATOR
Green Flash = charging
Green = fully charged
BATTERY LEVEL INDICATOR
Battery indicator lights up for 10 seconds when the headtorch is turned on.
Green = 65% – 100%
Orange = 30% – 65%
Red = 5% – 30%
Red Flash = less than 5%
References
- Register Unilite Warranty Here - Unilite - Portable LED Work Lights
- Ultra Bright, Portable LED Work Lights & Hand Tools | Unilite
- Ultra Bright, Portable LED Work Lights & Hand Tools | Unilite
- Register Unilite Warranty Here - Unilite UK
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>