Pablo 94124 Circa Pendant Light Installation Guide
- June 12, 2024
- Pablo
Table of Contents
Pablo 94124 Circa Pendant Light
IMPORTANT: WE RECOMMEND FIXTURE BE INSTALLED BY AN ELECTRICIAN
WARNING: FIXTURE MUST BE WIRED CORRECTLY OR RISK DAMAGE TO COMPONENTS
COMPONENT LIST
- A MOUNTING PLATE
- B TRANSFORMER
- C JUNCTION BOX SCREWS
- D CANOPY COVER SCREWS
- E CANOPY COVER
- F LAMP HEAD
- G DRYWALL ANCHOR
- H SWAG MOUNT BODY
- | SWAG MOUNT SCREW
- J SWAG MOUNT CAP
NOTE: IF JUNCTION BOX IS NOT LOCATED IN THE DESIREDPOSITION FOR CIRCA PENDANT, SEE BACK PAGE FOR SWAG
MOUNT INSTALLATION
-
ROUTE BUILDING WIRING THROUGH MOUNTING PLATE, THEN ATTACH PLATE TO JUNCTION BOX
-
ROUTE FIXTURE AND BUILDING CORDS AS SHOWN,THEN PULL CIRCA PENDANT TO DESIRED HEIGHT AND SET STRAIN RELIEF
-
CUT FIXTURE CORD TO DESIRED LENGTH, ADDING AN ADDITIONAL 3 INCHES (7.6 CM) FOR WIRING
-
BUILDING WIRING
CONNECT BUILDING WIRING TO 2 POLE CONNECTOR ON AC INPUT SIDE OF TRANSFORMER
-
FIXTURE WIRING
CONNECT FIXTURE WIRING TO 2 POLE CONNECTOR ON DC OUTPUT SIDE OF TRANSFORMER
-
TUCK WIRES AND POLE CONNECTIONS INTO CANOPY COVER, THEN SLIDE COVER PLATE UP TO CEILING AND SECURE WITH SUPPLIED SCREWS
SWAG MOUNT INSTALLATION
IF JUNCTION BOX IS NOT LOCATED IN DESIRED POSITION OF LIGHT, FOLLOW THESE
ADDITIONAL STEPS:
POSITION ANCHOR OVER DESIRED PENDANT LOCATION ON CEILING. TAP ANCHOR INTO THE CEILING, THEN USE A PHILLIPS SCREWDRIVER TO COMPLETE INSTALLATION HOLD SWAG MOUNT BODY FLUSH TO ANCHOR AND FASTEN TO ANCHOR USING PROVIDED SCREW
-
BULB TYPE
LED FLAT PANEL -
BULB REPLACEMENT
CONTACT MANUFACTURER FOR BULB REPI ACEMENT -
CORD LENGTH
10FT (305CM) -
ELECTRONIC
LOW VOLTAGE DIMMER RECOMMENDED -
CARE INSTRUCTIONS
WIPE CLEAN WITH A SOFT DAMP CLOTH. AVOID AMMONIA-BASED CLEANERS.
ADJUSTMENT
- INFO@PABLODESIGNS.COM.
- 888 MARIN STREET
- SAN FRANCISCO, CA
- 94124
- PABLODESIGNS.COM.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>