Pablo LANA Wall SM Series Lamp Instruction Manual

Pablo LANA Wall SM Series Lamp

WALL PLATE AND TABLE BASE

LANA MODELS

NOTE: WALL PLATE INCLUDED WITH EVERY MODEL

1. WALL PLATE INSTALLATION
   • IF THE FIXTURE IS BEING INSTALLED ONTO DRYWALL, USE PROVIDED, WALL ANCHOR. TAP THE UNTHREADED TIP OF THE WALL ANCHOR INTO THE WALL, THEN USE A PHILLIPS SCREWDRIVER TO COMPLETE THE INSTALLATION
2. FIX THE WALL PLATE TO THE WALL USING THE PROVIDED SCREW, AND ENSURE THE EDGE OF THE PLATE IS FLUSH WITH THE WALL

NOTE: IF MOUNTING ONTO A WOODEN STUD, DO NOT USE A WALL ANCHOR
NOTE: A WALL PLATE IS INCLUDED WITH EVERY MODEL

TABLE BASE ASSEMBLY

USE PROVIDED 3MM HEX TOOL AND 2 MACHINE SCREWS TO FIX THE POST TO BASE

FLOOR BASE ASSEMBLY

USE PROVIDED 3MM HEX TOOL AND 3 MACHINE SCREwS TO FIX POST TO BASE

1. PEDESTAL INSTALLATION
   

   • (OPTIONAL ACCESSORY)
     

   • USE THE PROVIDED SCREWDRIVER TO UNSCREW CLEAR PLASTIC SET SCREW. SLIDE PEDESTAL OVER FLOOR POST AND TIGHTEN SET SCREW UNTIL IT NTACTS POST. PEDESTAL SHOULD SLIDE UP AND DOWN EASILY

2. SLIDE THE PEDESTAL TO DESIRED HEIGHT, THEN TIGHTEN KNOB TO FIX IN PLACE

SHADE INSTALLATION

MAGNETIZE SHADE To WALL PLATE

MAGNETIZE SHADE TO TABLE OR FLOOR POST

ADJUSTMENT

SWITCH FUNCTION

• TAP OPTICAL SWITCH BRIEFLY CYCLES THROUGH HIGH, LOW, AND OFF. PRESS AND HOLD THE OPTICAL SWITCH TO ACTIVATE FULL RANGE DIM CONTROL. RELEASE FINGER FROM OPTICAL SWITCH WHEN DESIRED LIGHT LEVEL IS REACHED

CARE INSTRUCTIONS

WIPE CLEAN WITH A SOFT DAMP CLOTH. AVOID AMMONIA-BASED CLEANERS

NOTE: CONTACT THE MANUFACTURER FOR ADDITIONAL PLUG TYPE REQUIREMENTS.

• INFO@PABLODESIGNS.COM
• 888 MARIN STREET
• SAN FRANCISCO, CA 94124
• PABLODESIGNS.COM

Documents / Resources

| Pablo LANA Wall SM Series Lamp [pdf] Instruction Manual
LANA Wall SM Series Lamp, LANA, Wall SM Series, Wall SM Series Lamp, Lamp
---|---

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>