Pablo UMAV2 UMA Portable Table Lamp Owner’s Manual

June 5, 2024
Pablo

Pablo UMAV2 UMA Portable Table Lamp

Pablo-UMAV2-UMA-Portable-Table-Lamp-image

UMA INDICATOR OVERVIEW

INDICATOR LIGHT FUNCTIONS:

POWER  INDICATOR LIGHT BREATHING WH ITE PLUGGED IN AND CHARGING
ILLUMINATED GREEN PLUGGED IN, FULLY CHARGED
BLUETOOTH INDI CATOR LIGHT ILLUMINATED BLUE WAITIN G FOR CO NNECT ION
--- --- ---
  BREATHIN G BLUE

NOT ILLUMINATED

| PAIRING MODE ACTIVATED
ACTIVE CONNECTION

Pablo-UMAV2-UMA-Portable-Table-Lamp-fig1

CHARGING UMA

UMA USES AN INTERNAL RECHARGEABLE LITHIUM POLYMER BATTERY THAT WILL LAST THE LIFETIME OF THE DEVICE. FULLY CHARGE UMA’S BATTERY PRIOR TO FIRST USE. TO CHARGE THE BATTERY, CONNECT UMA TO THE INCLUDED POWER SUPPLY AND KEEP IT CONNECTED TO THE POWER SOURCE UNTIL POWER INDICATOR LIGHT TURNS GREEN. IT MAY TAKE UP TO 2.5 HOURS TO FULLY CHARGE UMA.Pablo-UMAV2-UMA-Portable-Table-
Lamp-fig2

UMA LIGHT FUNCTION

PRESS POWER SWITCH BRIEFLY TO TURN UMA ON. POWER INDICATOR LIGHT WILL ILLUMINATE. TURN LIGHT CONTROL RING CLOCKWISE PAST “CLICK” TO TURN ON LIGHT. ROTATE LIGHT CONTROL RING TO ACTIVATE FULL RANGE DIM CONTROL

CONTROLS
  • ROTATE CLOCKWISE TO INCREASE LIGHT
  • ROTATE COUNTERCLOCKWISE TO DECREASE LIGHT
  • PHYSICAL ‘CLICK’ REGISTRATION INDICATES LIGHT IS OFFPablo-UMAV2-UMA-Portable-Table-Lamp-fig3 NOTE:
    UMA WILL TURN OFF AUTOMATICALLY AFTER 15 MINUTES OF INACTIVITY.
    (INACTIVITY = LIGHT IS OFF & NO SOUND IS PLAYING)

UMA VOLUME FUNCTION

VOLUME IS CONTROLLED THROUGH A TOUCH-CAPACITIVE PAD ON THE TOP OF UMA. USING YOUR FINGER, SLIDE CLOCKWISE TO TURN VOLUME UP, SLIDE ANTI CLOCKWISE TO TURN VOLUME DOWN

CONTROLS
  • TOUCH INTERFACE
  • REQUIRES 360 DEGREES OF TOUCH ROTATION TO TRAVEL FROM 0%-100% VOLUME
  • SLIDE FINGER CLOCKWISE TO INCREASE VOLUME
  • SLIDE FINGER COUNTERCLOCKWISE TO DECREASE VOLUME
  • VOLUME IS CONTROLLED BY DIRECTION AND DISTANCE OF SLIDE REGARDLESS OF POSITION NOTE:
    UMA WILL TURN OFF AUTOMATICALLY AFTER 15 MINUTES OF INACTIVITY.
    (INACTIVITY = LIGHT IS OFF & NO SOUND IS PLAYING)

CONNECTING

CONNECTING UMA TO A BLUETOOTH® WIRELESS TECHNOLOGY ENABLED DEVICE

PAIRING:
WHEN CONNECTING A BLUETOOTH DEVICE TO UMA FOR THE FIRST TIME, THE DEVICE MUST BE REGISTERED TO UMA. THIS IS CALLED PAIRING. ONCE PAIRING IS COMPLETED, UMA WILL REMEMBER YOUR DEVICE AND CONNECT AUTOMATICALLY. UMA CAN REMEMBER UP TO 8 DEVICES. TO PAIR YOUR DEVICE WITH UMA, FOLLOW THESE STEPS:

  1. PRESS POWER SWITCH BRIEFLY TO TURN UMA ON. POWER INDICATOR LIGHT WILL ILLUMINATE.
  2. PRESS AND HOLD THE BLUETOOTH PAIRING BUTTON ON UMA FOR ONE SECOND TO PUT UMA INTO PAIRING MODE, INDICATED BY A BREATHING BLUE LIGHT. UMA WILL REMAIN IN PAIRING MODE UNTIL A CONNECTION IS MADE, OR FOR UP TO ONE MINUTE.
  3. TURN ON THE BLUETOOTH FUNCTION ON YOUR DEVICE.
  4. IN THE BLUETOOTH SETTINGS OF THE DEVICE, SELECT “UMA SOUND LANTERN” FROM THE LIST OF AVAILABLE CONNECTIONS.
  5. BLUETOOTH INDICATOR LIGHT ON UMA WILL CHANGE TO SOLID BLUE WHEN THE CONNECTION IS SUCCESSFUL. AFTER 10 SECONDS OF CONNECTION, INDICATOR LIGHT WILL TURN OFF.
  6. PLAY MUSIC ON YOUR DEVICE. ENSURE VOLUME ON YOUR DEVICE IS NOT SET TO MUTE.
  7. AFTER YOUR DEVICE HAS PAIRED WITH UMA, IT WILL CONNECT AUTOMATICALLY. IF IT DOES NOT CONNECT AUTOMATICALLY, REPEAT THE PAIRING PROCESS TO REGISTER YOUR DEVICE.Pablo-UMAV2-UMA-Portable-Table-Lamp-fig5 IF YOU HAVE DIFFICULTY CONNECTING TO UMA, PLEASE REFER TO THE TROUBLESHOOTING GUIDE IN THIS INSTRUCTION MANUAL.

CONNECTING UMA TO A DEVICE VIA PROVIDED AUXILLIARY CABLE

UMA CAN PLAY MUSIC FROM AN AUDIO DEVICE BY CONNECTING AN AUX IN CABLE. TO CONNECT YOUR DEVICE TO UMA WITH AUXILIARY CABLE, FOLLOW THESE STEPS

  1. PRESS POWER SWITCH BRIEFLY TO TURN UMA ON. POWER INDICATOR LIGHT WILL ILLUMINATE.
  2. PLUG AUXILLIARY CABLE INTO UMA AUDIO-IN PORT. BLUETOOTH WIRELESS TECHNOLOGY WILL BE DISABLED AND ALL WIRELESS CONNECTIONS WILL BE DISCONNECTED.
  3. PLUG THE OTHER END OF THE AUXILLIARY CABLE INTO THE AUDIO-OUT (HEADPHONE) PORT ON YOUR DEVICE.
  4. PLAY MUSIC ON YOUR DEVICE. ENSURE VOLUME ON YOUR DEVICE IS NOT MUTED.
    NOTE: AUXILLIARY CABLE IS NON-DIRECTIONALPablo-UMAV2-UMA-Portable-
Table-Lamp-fig6

SURFACE MOUNT OPTION

UMA CAN BE BOLTED TO A SURFACE USING A STANDARD M6 X 1MM MACHINE SCREW (NOT PROVIDED).
SCREW LENGTH IS DETERMINED BY ADDING THE TABLE THICKNESS TO THE 10MM INSERT LENGTH.Pablo-UMAV2-UMA-Portable-Table-Lamp-fig7

TRANSPORTING UMA

UMA IS INTENDED TO BE TRANSPORTED IN THE INCLUDED CLOTH BAG FOR CONVENIENT AND PROTECTED TRAVEL.
UMA CAN BE OPERATED WHILE IN THE TRAVEL BAG, AND IS RECOMMENDED IN DAMP CONDITIONS.Pablo-UMAV2-UMA-Portable-Table-Lamp-fig8

CARE INSTRUCTIONS

WIPE UMA CLEAN WITH A SOFT DAMP CLOTH. AVOID AMMONIA- BASED CLEANERS. PROTECT UMA WITH THE PROVIDED CARRY BAG WHEN TRANSPORTING. DO NOT SUBMERGE OR EXPOSE TO RAINFALL OR SPLASHING WATER.

BLUETOOTH® WIRELESS TECHNOLOGY CONNECTION TROUBLESHOOTING GUIDE

IF YOU HAVE DIFFICULTY CONNECTING YOUR DEVICE TO UMA, FOLLOW THIS GUIDE

PROBLEM CAUSE SOLUTION

UMA CANNOT MAKE A BLUETOOTH

CONNECTION

| UMA IS TURNED OFF| PRESS POWER SWITCH BRIEFLY TO TURN UMA ON. POWER INDICATOR LIGHT WILL ILLUMINATE
BLUETOOTH FUNCTION IS TURNED OFF| PRESS THE BLUETOOTH BUTTON TO ENABLE BLUETOOTH FUNCTION
UMA HAS NOT YET BEEN PAIRED WITH THE BLUETOOTH DEVICE| PERFORM PAIRING PROCESS
UMA IS TOO FAR FROM THE

BLUETOOTH DEVICE

| MOVE THE AUDIO SOURCE CLOSER. MAXIMUM DISTANCE FROM DEVICE IS 30M UNOBSTRUCTED
AN AUX-IN CABLE IS CONNECTED| DISCONNECT AUX-IN CABLE
ANOTHER BLUETOOTH DEVICE IS CONNECTED| DISCONNECT OR POWER OFF THE OTHER BLUETOOTH DEVICE
THE PAIRING INFORMATION HAS BEEN DELETED. UMA CAN REMEMBER UP TO 8 DEVICE PAIRINGS . IF A 9TH DEVICE IS PAIRED, UMA WILL FORGET THE

FIRST DEVICE

| PERFORM PAIRING PROCE SS AGAIN
UMA IS NOT REGISTERED ON THE DEVICE’S BLUETOOTH CONNECTION

LIST

| PERFORM PAIRING PROCESS AGAIN
THERE IS A DEVICE (MICROWAVE, WIRELESS LAN, ETC.) THAT OUTPUTS SIGNALS IN THE 2.4 GHz FREQUENCY BAND NEARBY| MOVE UMA AWAY FROM  ANY DEVICE THAT EMITS RF SIGNALS OR INTERFERENCE

LIGHT AND AUDIO FUNCTION TROUBLESHOOTING GUIDE

PROBLEM CAUSE SOLUTION
BLUETOOTH AUDIO CONNECTION IS DISTORTED OR DROPPING OUT THE SOURCE DEVICE IS
TOO FAR AWAY FROM UMA MOVE THE AUDIO SOURCE CLOSER MAXIMUM DISTANCE FROM

DEVICE IS 10M
THERE IS A DEVICE (MICROWAVE, WIRE LESS LAN, ETC.) THAT OUTPUTS SIGNALS IN THE 2.4 GHz FREQUENCY BAND NEARBY| MOVE UMA AWAY FROM ANY DEVICE THAT EMITS RF SIGNALS OR INTERFERENCE
THE VOLUME ON EITHER THE AUDIO SOURCE OR UMA IS TOO LOW| ADJUST THE VOLUME ON BOTH UMA AND  THE AUDIO SOURCE
POOR CONNECTION BETWEEN UMA AND THE SOURCE DEVICE| RESTART BOTH THE AUDIO SOURCE AND UMA
BLUETOOTH PAIRING FAILED| RE-PAIR YOUR DEVICE WITH UMA
SOURCE DEVICE IS PAIRED TO A DIFFERENT BLUETOOTH DEVICE| DISCONNECT OR POWER OFF THE OTHER BLUETOOTH DEVICE
3.5MM AUXILLIARY AUDIO CONNECTION IS DISTORTED OR DROPPING OUT| 3.5MM AUXILLIARY CABLE IS NOT FULLY CONNECTED TO EITHER UMA OR THE SOURCE DEVICE| CHECK THAT THE 3.5MM AUXILLIARY CABLE IS SECURELY CONNECTED TO BOTH UMA AND THE SOURCE DEVICE
SOURCE DEVICE ISN’T WORKING  PROPERLY| TRY A DIFFERENT SOUCE DEVICE TO ENSURE THE ISSUE ISN’T THE SOURCE DEVICE
3.5MM AUXILLIARY CABLE IS FAULTY OR DAMAGED| TRY A DIFFERENT 3.5MM AUXILLIARY CABLE
STREAMED AUDIO CONTENT IS DISTORTED OR DROPPING OUT| INTERNET CONNECTIVITY ISSUES| FOLLOW YOUR ROUTER/ISP INSTRUCTIONS TO ENSURE YOUR INTERNET CONNECTION IS FUNTIONING PROPERLY
UMA POWER IS ON LANTERN DOES NOT ILLUMINATE| DIMMER CONTROL RING IS TURNED OFF| ENSURE DIMMER CONTROL RING IS TURNED CLOCKWISE PAST THE ‘CLICK’ TO ILLUMINATE
AUTO SHUT-OFF IS NOT WORKING| LIGHT IS STILL ON OR SOUND IS STILL PLAYING| MUST TURN OFF LIGHT AND SOUND SOURCE FOR AUTO SHUT-OFF TO FUNCTION

MORE INFO

FOR MORE INFORMATION AND PRODUCT DETAILS VISIT WWW.PABLODESIGNS.COM

SPECIFICATIONS

  • LIGHT OUTPUT: 18O LUMENS MAX
  • BATTERY RUNTIME: 5 TO B HOURS DEPENDING ON USE
  • CHARGE TIME: UP TO 2.5 HOURS
  • POWER ADAPTER INPUT: 100-240V – 50/60Hz 1.3A MAX
  • POWER CONSUMPTION: 6.5W (LIGHT) 12W MAX (SPEAKERS)
  • SPEAKER WATTAGE: 12W MAX 1.5W TYPICAL
  • BLUETOOTH VERSION: 4.1
  • BLUETOOTH RANGE: 10M
  • DIMENSIONS: 11″ x 6″ x 6″ (28cm x 15.4cm x 15.4cm)
  • WEIGHT: 2.85lbs (1.3kgs)
    PATENT PENDING MADE IN CHINA

WARRANTY

FOR WARRANTY AND ADDITIONAL TROUBLESHOOTING INFORMATION VISIT WWW.PABLODESIGNS.COM/PRODUCT/UMA
FOLLOW US
FOLLOW US ON FACEBOOK AND INSTAGRAM
WWW.FACEBOOK.COM/PABLODESIGNSSF
@PABLODESIGNSSF

SAFETY INFORMATION

PLEASE READ THESE SAFETY WARNINGS AND CAUTIONS CAREFUU.Y

WARNING

FIRE AND ELECTRIC SHOCK HAZARD

  • NEVER USE UMA NEAR A BATHTUB, SHOWER, SINK, SAUNA, POOL, OR STEAM ROOM. DEATH OR SERIOUS PERSONAL INJURY FROM ELECTROCUTION WILL RESULT.
  • DO NOT EXPOSE YOUR UMA TO LIQUID. MOISTURE, HUMIDITY, OR RAIN. EXPOSURE OF UMA TO MOISTURE COULD RESULT IN ELECTRIC SHOCK.
  • DO NOT DROP, DISASSEMBLE, OPEN, CRUSH, BEND, DEFORM, PUNCTURE, SHRED, MICROWAVE, INCINERATE, PAINT, OR INSERT FOREIGN OBJECTS IN TO UMA. SUCH ACTIONS COULD RESULT IN ELECTRIC SHOCK
  • DO NOT ATTEMPT TO DISASSEMBLE UMA OR FORCE OPEN THE BUILT-IN BATTERY IN DAMP AREAS OR IN EXTREMELY HIGH OR LOW TEMPERATURES BECAUSE THI$ COULD RESULT IN ELECTRIC SHOCK
  • DO NOT CLEAN UMA WHEN IT IS BEING CHARGED. ALWAYS UNPUJO UMA BEFORE CLEANING.
  • CLEAN UMA ONLY WITH A DRY CLOTH.

CAUTION

  • DO NOT A TEMPT TO REPLACE YOUR UMA’SBATTERY;ITISBUILT-INANDIS NOT CHANGEABLE. FAILURE TO FOLLOW THIS WARNING MAY RESULT IN SERIOUS PERSONAL INJURY
  • DO NOT AITTMPT TO REPAIR. MODIFY,  OR DISASSEMBLE YOUR UMA YOURSELF;  IT DOES NOT CONTAIN ANY   USER-SERVICEABLE COMPONENTS.
  • DO NOT USE ABRASIVE CLEANERS TO  CLEAN YOUR UMA BECAUSE THIS COULD  CAUSE SCRATCHES AND DAMAGE.
  • DO NOT BRING YOUR UMA IN TO  CONTACT WITH AN’f SHARP OBJECTS BECAUSE THIS COULD CAUSE  SCRATCHES AND DAMAGE.
  • DO NOT INSERT ANYTHING INTO YOUR UMA UNLESS OTHERWISE SPECIFIED IN THE USER INSTRUCTIONS. THIS MAY DAMAGE THE INTERNAL COMPOMENTS
  • OBSERVE ALL SIGNS AND DISPLAYS THAT  REQUIRE AN ELECTRICAL DEVICE OR RF RADIO PRODUCT TO BE SWITCHED OFF IN DESIGNATED AREAS.
  • TURNOFF YOUR UMA PRIOR TO BOARDING AN AIRCRAFT. DO NOT USE UMA INSIDE AN AIRCRAFT UNLESS ALLOWED BY YOUR AIRLINE.

FCC NOTICE

THIS EQUIPMENT HAS BEEN TESTED AND FOUND TO COMPLY WITH THE LIMITS FOR A CL.ASS B DIGITAL DEVICE, PURSUANTTO PART 15 OF THE FCC RULES. THESE LIMITS ARE DESIGNED TO PROVIDE REASONABLE PROTECTION AGAINST HARMFUL INTERFERENCE IN A RESIDENTIAL INSTALLATION. THIS EQUIPMENT GENERATES, USES, AND CAN RADIATE RADIO FREQUENCY ENERGY AND. IF NOT INSTALLED AND USED IN ACCORDANCE WITH THE INSTRUCTIONS, MAY CAUSE HARMFUL INTERFERENCE TO RADIO COMMUNICATIONS. HOWEVER, THERE 15 NO GUARANTEE THAT INTERFERENCE WILL NOT OCCUR IN A PARTICULAR INSTALLATION. IF THIS EQUIPMENT DOES CAUSE HARMFUL INTERFERENCE TO RADIO OR TELEVISION RECEPTION, WHICH CAN BE DETERMINED BY TURNING THE EQUIPMENT OFF AND ON, THE USER IS ENCOURAGED TO TRY TO CORRECT THE

INTERFERENCE BY ONE OF THE FOLLOWING MEASURES:

  • REORIENT OR RELOCATE THE RECEIVING ANTENNA.
  • INCREASE THE SEPARATION BETWEEN THE EQUIPMENT AND RECEIVER.
  • CONNECT THE EQUIPMENT INTO AN OUTLET ON A CIRCUIT DIFFERENT FROM THAT TO WHICH THE RECEIVER IS CONNECTED.
  • CONSULT THE DEALER OR AN EXPERIENCED RADIO/TV TECHNICIAN FOR HELP

THIS DEVICE COMPLIES WITH PART15 OF

THE FCC RULES. OPERATION IS SUBJECT TO THE FOLLOWING TWO CONDITIONS:

  1. THIS DEVICE MAY NOT CAUSE HARMFUL INTERFERENCE, AND
  2. THIS DEVICE MUST ACCEPT ANY INTERFERENCE RECIEVED, INCLUDING INTERFERENCE THAT MAY CAUSE UNDESIRED OPERATION.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals