U-Turn Audio Iso-Level Feet User Guide
- June 12, 2024
- U-Turn Audio
Table of Contents
U-Turn Audio Iso-Level Feet
Product Information
Setup Guide
Getting started
- Unplug turntable. Remove belt, platter, and spindle. Secure tonearm to tonearm rest using twist tie (included).
- With dust cover attached and closed, flip turntable upside down. Place on a soft surface like a towel to avoid scratching dust cover.
- Use a #2 Phillips-head screwdriver (not included) to unscrew and remove original rubber feet and screws.
Pick screw size
Original foot screws need to be replaced. There are two replacement screw
sizes included. Use the guide below (actual sizes shown) to determine which
screw size to use.
| Size #6 (original) | Size #14 (new) |
|---|---|
| original size | new size |
Install foot housings
Remove plastic film from Sorbothane pads. Screw housings into the bottom of
the plinth until firmly seated using a #2 Phillips-head screwdriver. Do not
overtighten screws.
| Front foot housing | Back foot housing |
|---|
Install feet
Screw feet into housings until the red O-ring is no longer visible.
| Foot | Red O-ring |
|---|
Level turntable
Place the turntable on a stable surface and install the spindle, platter,
and belt. Position the bubble level (included) anywhere on top of the plinth.
Bubble level
Level turntable continued
If the bubble is not centered, adjust the height of the feet to level the
turntable. Turn the bottom of the foot to raise or lower it.
| Bubble position Adjustment | Turntable is level |
|---|---|
| Lower back foot or raise front feet | Raise the front left foot or lower front |
right and back foot
Additional support
- Setup videos & tutorials: uturnaudio.com/learn
- Email: support@uturnaudio.com
- Phone: 781-451-1445
We stand by our products with a 3-year warranty that covers any defects in materials or workmanship.
Getting started
- Unplug turntable. Remove the belt, platter, and spindle. Secure tonearm to tonearm rest using a twist tie (included).
- With the dust cover attached and closed, flip the turntable upside down. Place on a soft surface like a towel to avoid scratching dust cover.
- Use a #2 Phillips-head screwdriver (not included) to unscrew and remove the original rubber feet and screws.
Pick screw size
Original foot screws need to be replaced. There are two replacement screw sizes included. Use the guide below (actual sizes shown) to determine which screw size to use.
Install foot housings
Remove plastic film from Sorbothane pads. Screw housings into the bottom of the plinth until firmly seated using a #2 Phillips-head screwdriver. Do not overtighten screws.
Install feet
Screw feet into housings until red O-ring is no longer visible.
Level turntable
Place the turntable on a stable surface and install a spindle, platter, and belt. Position bubble level (included) anywhere on top of plinth.
Level turntable continued
If the bubble is not centered, adjust the height of the feet to level the turntable. Turn the bottom of the foot to raise or lower it.
Additional support
- Set up videos & tutorials at uturnaudio.com/learn.
- Emailsupport@uturnaudio.com.
- Phone781-451-1445
- We stand by our products with a 3-year warranty that covers any defects in materials or workmanship.
© 2023 U-Turn Audio, Inc.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>