carmanah MX Series Audible Push Button Kit Installation Guide
- June 12, 2024
- carmanah
Table of Contents
MX Series
AUDIBLE PUSH BUTTON KIT INSTALL GUIDE LEVEL 4 
MX Series Audible Push Button Kit
NOTE ADA regulations specify that button should be 42″ from the ground.
NOTE Refer to button manufacturer’s documentation for additional setup
and configuration information.
NOTE Two or fewer parallel-connected buttons recommended per module
trigger input.
NOTE Contact Carmina for guidance on installing audible push buttons not
listed in this guide.
- Prepare pole and install button base per button manufacturer’s instructions.
- Ensure cable entry hole is deburred and button base sits flush against pole.
- Fish cable through pole and button base.
- Campbell buttons only: fold and tape (or cut at end of jacket if permitted by local regulations) unused brown wire at both end of cable.
- Connect wires to button terminal as shown in table below.
Terminal Reference| Power or Flasher Module Terminal Function| Wire Color|
---|---|---|---
A| Input +| White
B| Input −| Green
C| 12V OUT +| Red
D| 12V OUT −| Black
E| CONFIRM +| Blue
F| CONFIRM −| Brown
- Install button or cover with its supplied hardware, ensuring any gaskets are in place and cable forms drip loop inside pole.
- Connect other end of cable to trigger input terminals A through F of any power or flasher module according to table above.
- Strain relieve cable per power or flasher module instructions.
NOTE Ensure tactile arrow on button is aligned with crossing direction.
NOTE : READ ALL INCLUDED INSTALL GUIDES BEFORE SYSTEM INSTALLATION
Carmina Technologies Corp. | 250 Bay St, Victoria, BC V9A 3K5,
Canada | 1.250.380.0052
customersupport@carmanah.com
carmanah.com
References
- Systems for Traffic Beacons and Signs | Solar LED Beacons | Carmanah
- Systems for Traffic Beacons and Signs | Solar LED Beacons | Carmanah
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>