edelkrone 81730 PhoneGRIP B and H Photo Video User Manual

edelkrone 81730 PhoneGRIP B and H Photo Video

Before operating your edelkrone, please watch the user’s manual video from the link below. http://edel.kr/pgp.

WHAT’S IN THE BOX & THE BASICS

1. PhoneGRIP
2. Cold shoe port
3. Cold shoe
4. Foldable piece
5. 1/4″-20 mounting hole
6. 1/4″-20 mounting hole
7. Tilt mechanism
8. Cold shoe
9. Stabilizer legs
10. Tension adjustment screw
11. 3/8″-16 mounting hole
12. 1/4″-20 mounting hole
13. Cold shoe port
14. 3/8″-16 to 1/4″-20 reducer bushing
15. 2.5 mm Allen key

ATTACHING DEVICES TO PHONE GRIP

You can mount any device between 55-85 mm to PhoneGRIP, such as smartphones or power banks.

1. Extend the marked clip as wide as your device.
2. Align your device with PhoneGRIP and place it between the clips.
3. Make sure the clips don’t press the side buttons of your device.

ATTACHING SMALL DEVICES TO PHONE GRIP

You can also mount smaller devices between 38-67 mm to PhoneGRIP, such as an SD or edelkrone Controller.

1. Fully unfold the clip marked PULL.
2. Align your device with PhoneGRIP and place it between the clips.
3. Make sure the clips don’t press the side buttons of your device.

ADJUSTING THE COLD SHOE ANGLE & 1/4″-20 MOUNTING HOLE

1. The cold shoe has a 1/4″-20 mounting hole at the bottom.
2. If you don’t want to mount with the cold shoe, you can disassemble the cold shoe and use the 1/4″-20 mounting hole which is placed under the cold shoe parts.
3. You can adjust your PhoneGRIP’s cold shoe angle by turning the cold shoe parts 45 degrees and assembling back when you need to mount your PhoneGRIP 45 degrees.

MOUNTING PHONE GRIP

ADJUSTING THE TENSION OF THE TILT MECHANISM

You can adjust the tension of the system with the help of a 2.5 mm Allen key. a

1. Simply tighten or loosen the screws.

ADJUSTING THE COLD SHOE ANGLE & 3/8″-16 MOUNTING HOLE

1. The cold shoe has a 1/4″-20 mounting hole at the bottom.
2. If you don’t want to mount with the cold shoe, you can disassemble the cold shoe and use the 3/8″-16 mounting hole or 3/8″-16 to 1/4″-20 reducing bushing which is placed under the cold shoe parts.
3. You can adiust your tilt mechanism’s cold shoe angle by turning the cold shoe parts 45 degrees and assembling back when you need to mount your PhoneGRIP 45 degrees,

USING THE TILT MECHANISM ON FLAT SURFACES

1. You can use the tilt mechanism on flat surfaces by removing the cold shoe part.
2. You can also use the tilt mechanism on flat surfaces with the cold shoe part by folding it in the opposite direction.
3. You can use the stabilizer legs to stabilize the tilt mechanism when needed by fully extending the legs as shown.

USAGE SCENARIOS

DISCLAIMER
edelkrone cannot be held responsible for damage caused by improper use or modification of the product.

For more information and tips on PhoneGRIP, please watch the user’s manual videos at: https://edel.kr/pgp.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>