Steelton 109RACKECON Full Height Bun Pan Rack Instruction Manual
- October 30, 2023
- Steelton
Table of Contents
109RACKECON Full Height Bun Pan Rack
Instruction Manual
FULL HEIGHT
BUN PAN RACK
109RACKECON Full Height Bun Pan Rack
TOOLS NEEDED : An Adjustable Wrench OR 10mm and 14mm Socket are required for assembly.
ASSEMBLY INSTRUCTIONS
INCLUDED PARTS
A (2) Pan Slide Frames
B (6) Crossbars
• (4) Top/Mid (Long)
• (2) Bottom (Short)
D (4) 5″ Casters
E (8) U Brackets
C (12) Bolts
• (8) 10mm (Top/Mid)
• (4) 14mm (Bottom)
FINAL PRODUCT
Need Help?
Scan here to follow along with the full assembly video!
https://www.youtube.com/watch?v=pZYggoq2LhI
ASSEMBLING THE PAN RACK
- Insert (2) Long Crossbars into the top holes of the Pan Slide Frames.
- Attach U Brackets (2 for each Crossbar) and to the outside of the Pan Slide Frames using the 10mm Bolts. Hand-tighten the bolts* and repeat the process for the other side.
- Repeat steps 1 & 2 for the (2) Middle Crossbars.
- Insert the (4) Casters** into the bottom of the Frames. The locking casters should be installed in the same end of the rack so they can easily be set.
- Once the casters are properly aligned, the remaining (2) Short Crossbars can be installed on the bottom of the rack using the 14mm Bolts.***
- Put a bun pan in both the top and bottom of the rack to ensure your bun pan is square.
- Tighten each bolt with a wrench. Your bun pan rack is now ready to use.
- NOTE: Be sure to not over-tighten the bolts, or you may damage the Frame and/or Crossbars.
NOTE:** Make sure the hole in the caster post is aligned with the hole in the collar.
* NOTE:** The bottom Crossbars do not require U Brackets, they can be bolted on directly though the hole in the collar.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>